hello guys quick demo on the speedskim better camera better footage more detail my poles
not the greatest on this speedskim we are going to flatten in the ceiling with it here
so a quick demo on the way i use it what i normally do is I will flatten it in and then
hope up and trowel it again make sure all the corners are nice and clean. I always just
give it a quick wet down i have just put the ceiling on with the stilts over here so obviously
I love the stilts but if I can avoid getting on to them for a trowel I will do it obviously
for safety reasons. as you can see not that much on the speedskim so its not like its
pull stuff of the ceiling if just leveling it in and flattening it in. dont want to be
pulling stuff of the ceiling wanna just fatten it in you can see a hollow there I will fill
that in in a second with a hawk and trowel. this is the wides speedskim there is shows
you how neat i got the ceiling on and the plasterboard that is is flattening in very
well you can see there still a couple of wee lines and its recommended to round that edge
off at the corner to no more than a 5p recommendation is but i haven't bothered rounding mine as
i dt mind the odd wee line as i can catch that on the next trowel and also i find if
you tend t round things on poroe it wont last as long so i just wanted to break it in ver
time but everybody's different . you can see i am covering a very large area about a bucket
and half on that ceiling its not a small ceiling its not a really big ceiling but it show how
quickly i'm flattening in. this rocut im using sets in about an hour an hour and 20 minutes
so something like this is quite good to have just dug it in there. like i say guys I use
it pretty much for quick fatten and a bit of a straight edge so that i know where in
the ceiling if there is any hallows i can fill the in before the stuff starts to go
off you can see the whole ceiling quickly flattened in still a few lines lo u ther a
few lines still but i jump up straight away hit it a quick trowel clean up the corners
it is definitely a lot fatter than what it was again that's all the came of guys minimal
give it a good wash when you're finished with it wouldn't recommend letting it set to the
elastic put the cover back on to stop the edges getting nicked thats it