Hey guys, in this video we're going to be installing a basin waste
This one's a pop-up style
It's 32 mm which suits the 32 mm outlet in this basin
...But the rest of our plumbing is 40 mm, So we've gotten a 32-40 mm PVC adapter
It actually came with it, which is handy
It's got a couple of overflow apertures
Which we need to line up with the overflow in the basin there
So if you ever leave the plug closed and the tap running, it will still let the water
In to there, rather than all over your bathroom floor
It's got a couple of rubber washers, which we're going to discard and actually install this plug using silicone,
which is a better seal,
and a flange nut.
So follow these steps and we'll get it installed
Before we put our silicone on around here. Just remove your plug - that unscrews, and you can also unscrew
the little spring plug mechanism
And we'll get our silicone on around the flange, the underside there.
Remembering to line up the overflow hole there
Reattach the plug mechanism
Just finger tight's fine
We're going to end up with some silicon squeezing out of the sides there
We won't worry about cleaning it up just yet, once we've tightened it all together
We'll give this a clean-up with um, like a paper towel and some soapy water
This is the 32 to 40 mm adapter for PVC, it's actually got a rubber seal there
so as we screw that up tight it doesn't need any thread sealing tape
its just got that washer at the bottom there.
re-connect our waste
Now there's a little bit of silicon that's squeezed out around there
Just double-check at this point that your overflow aperture there is lining up
and replace, or install your plug
Done, nice easy job!
Okay, so 2 important points I think that we need to remember is to...
line up the overflow waste holes, when we screw that waste down nice and tight to the basin.
and now the one is to use silicone (and put plenty on)
rather than the rubber washers that come with the drain and
When you when you tighten it up and the silicone squeezes out
Just clean that up with paper towel and some soapy water and it will give you a really good seal
Alright, if you found this video helpful, give it a thumbs up. I appreciate that and I will see you on the next one. Bye