in this video we're going to make these dividers for a tool box these stop the
tools from sliding all over the place a particular problem with the tool box that
I have on site is that you put the tools in nice and neat and then you go somewhere you come
back and the tools are spread all over the place making it very difficult to
find them by using these dividers you can actually keep all your tools in some
kind of order inside of the box so that's a common scenario when you open your box all your tools are
spread out all over the place so it's got exactly the same
amount of tools in as it had before but they are a lot better organized as you
can see you can quite easily find each tool. I'm going to start off by trimming these
pieces to size you will notice that I've got about four pieces together that is
called pack cutting this should cut through all four pieces very quickly
indeed
this has that been cut to the correct size I'm now going to fold it at
approximately 45 millimeters in from each edge 90 degrees so I'm going to start
off by removing the masking and as you can see that is a fluorescent colour so
that looks very smart so I'll just leave that on there for a couple of minutes until
it gets warm enough
once I've got it hot enough I can then remove it from the nichrome wire and
hold it in position until it cools
after a couple of minutes it's cold and off you can then let go of it
I have done a video on how to make a line bending machine - which is very simple
and only takes couple of hours
I'd like to thank you for watching this video if you haven't done so already
please subscribe to the channel
you