Welcome back to Albany County Fasteners - Fasteners 101.
Today we're gonna be reviewing Drill and Tap Combo by Norseman Viking so let's get started.
So let's start the review. So these are Norseman Viking Drill Tap Combo Bits.
They have they have gold oxy, they're two in one combo bits,
self-centering so no matter how you, how you point your bit in it's gonna self-center and drill straight.
It has the three flats so you won't have any slippage
and it also reduces clogging.
Should be used with drill lubricant. High speed steel. You get this nylon patch so you can close it or wrap it up you.
You can put it on your belt, if you want, so very nice for the handyman.
Now if I can get it off...
It has seven combo bits. of seven combo bits.
So this is one of them. There are four up here, three down here.
Total of seven combo bits. You get an:
#8-32
a #10-24
a 1/4"-20
5/16"-18
3/8"-16
7/16"-14
and a 1/2"-13.
The tip is a 135 degree.
So these are awesome.
Here is your drill point that, you're drilling in to the steel
and then here is your tap. All built into one, one function no switching; from a bit to a tap. Time saving.
This is awesome for the hollow metal door installations.
Those of you who have piano hinges or anything of that sort to install,
54 screws into one hinge, this is the baby.
So lets get started. Let's test it
and we're gonna go through a 3/8ths piece of structural steel.
We're gonna see how well this USA made bit performs.
So I installed into my drill a 1/4"-20 drill tap.
So we're gonna be drilling into this 3/8ths steel. 1/4"-20.
That's what we are tapping for, a 1/4"-20 screw.
First i'm going to
put a little lubricant on here.
This is the Norseman Viking lube.
So,
we're gonna get started.
Wow, there we go.
Gonna grab a screw.
Look at that.
Awesome, that is an amazing fit.
You probably get about, I would say...
I would say probably about...
depends on what you are going through. If you're going through steel like this,
3/8" steel, you're probably looking at somewhere
20 maybe 30 taps, drilling taps that you can go through.
This is not hot, you can see, i'm touching it. So using that lubricant,
is very very key. I'm touching with my fingers and if you didn't use lubricant
than you're just going to burn out the bit. So it's very important to use those
lubricants, you saw how fast that was. Took me like 30 seconds I think
to drill that out and tap it. BAM!
So there you go,
one awesome set.
You gotta go and get one of these.
It's a must have in your toolbox. For those moments, when you're just trying to drill and tap something out.
Subscribe, Like and Comment below
Visit us at albanycountyfasteners.com, you can find this on our website.
You can purchase them right there. They also are available in single sizes.
Ready to ship. Right off our shelves. 50,000 Skus.
We look forward to seeing you in our next video.