Hi guys, welcome back to geardo. Today we will show you how to replace the battery on iPad Air 2.
Before Starting, we need to have the right tools to proceed with the repair,
which You can find in the description.
Proper heating is essential to separate the screen from the body for tablet repair. For this,
we use a heating pad designed for tablets and mobile phones. On iPad Air, make sure
to heat the front side. Select the Tablet heating option and leave it till the heating completes.
Alternatively, you can use a heat gun or hairdryer.
Once the heating has completed, use a suction cup on the sides to lift the front screen.
In between, Insert a Plastic Card pry tool or triangle picker and cut the adhesive around.
Be gentle while pulling; there are flex cables attached to the logic board.
To lift the lcd assembly, take a 45% degree direction from the top
side of the screen to the bottom. Keep it steady till removing the LCD Screen.
Next, Take out the shield by removing three screws and then disconnect both screen connector plugs.
and now the screen unit can leave the body.
Next, take out the screw to loosen the battery connector from the board.
Next, To lift the battery needs some more extra heating on the battery side.
If you are using a heat gun, Be cautious, and apply the heat to release the battery's adhesive.
Again we are using the heating pad, but on the rear side, where the battery locates.
Next, use a couple of pry tools and card pry tools to lift the battery and cut the
adhesive on the bottom. Be gentle, and raise the battery slowly while cutting the glue.
Next, gently lift the logic board from near to the battery connector.
Slowly raise the board using a pry tool and then pull out the battery.
The bottom of the connector, the sticky, can be a little strong,
be careful, and slowly cut the adhesive to pull the battery using a pry tool. There
is no connector plug, and the Battery pins are touching the logic board pins.
Next, place the new battery on the board with adhesive;
make sure to lift the board to place the battery connector in the slot.
And then secure the battery screw on the logic board.
Next, connect the LCD Assembly to the board and secure the shield by adding three screws.
Next, Ensure the screen and touch functionality and clamp up the iPad Air2 , ensure it has
enough glue on it. If not, can use B7000 glue or Double-sided pre-cut adhesives.
Place the screen from the bottom to the top and then simultaneously click
sides and the bottom. Ensure to put pressure on the frame
sides and verify that the home button sits and clicks orderly.
Finally, we are using screen binding clips to tighten the screen to the body.
If not, you can use rubber bands and leave them for some time.
I
hope you have enjoyed the Repair guide
Let us know if you have any questions; please like, share, and comment on our videos.
Do not forget to hit the subscribe button.