Hello everyone, today I show you how to disassemble iPhone 6s Plus and replace motherboard
What tools do you need for disassembling the iPhone 6s Plus:
• Screwdriver set Pentalobe – 0,8mm and Phillips – PH00 1.5mm
• Plastic mediator • Suction cup for removing touchscreens
• Tweezers and opening plastic tool In the description of this video, I left links
to the necessary tools and parts for replacement.
Before disassembling, turn off the iPhone and remove the sim card tray.
Unscrew two screws near the connector for charging.
Display glued around perimeter of iPhone and we need to heat the surface of iPhone for
open it.
For this, I use a hairdryer.
Apply a suction cup near home button and pull up on the ring of suction cup.
Using a plastic opening tool, separate the display from the iPhone case.
Gently and evenly, separate on both sides.
Open the display by lifting it up.
In iPhone 6s Plus uses different sizes of screws, and in order not to confuse them during
assembly, I recommend using a magnetic pad.
Remove two screws securing the battery connector bracket on the motherboard.
Use the plastic tool for disconnect the battery cable from the motherboard.
Unscrew the 5 screws and remove the bracket.
Next, disconnect 3 cables from the logic board.
Disconnect all cables and antennas from the motherboard iPhone 6s Plus.
Unscrew the two screws on the bracket and remove it.
After, disconnect one more cable from the motherboard.
Unscrew two screws and remove plastic bracket.
Next, unscrew two more screws on motherboard.
Carefully rise the motherboard of iPhone 6s Plus.
On the backside of the motherboard, disconnect one more antenna.
Now let's go install the motherboard and assemble the iPhone 6s Plus.
Connect the antenna cable to the motherboard and place the motherboard in the iPhone case.
Securing the two screws on the motherboard.
Connect each cable and antenna to the motherboard iPhone 6s Plus.
Insert the sim card tray and make sure that nothing interferes.
Set the bracket and screw the 2 screws.
Next, install the plastic bracket and screw the 2 screws.
Set the camera in the case and connect the cable to
the motherboard.
First, install the Bluetooth antenna and then install the bracket on top.
Fasten 3 screws.
Remove the old glue from the iPhone case.
Now take adhesive tape and apply to the case of the iPhone.
Also I left link to this adhesive tape in description.
Set the display and connect three cables, then connect the battery cable.
Set the metal bracket on the cable and securing the one screw in the middle.
After fasten the remaining 4 screws.
Now set the metal bracket on the battery cable and fasten two screws.
Fasten two screws near the lightning port.
Now we can turn on the iPhone 6s plus and use it.