(soft music)
(upbeat music)
- [Instructor] Drive the compact tractor to the loader,
and center the tractor wheels between the loader arms.
Continue forward until the loader frame
contacts the loader mount.
Stop the engine and set the parking brake.
Relieve hydraulic pressure
by moving the joystick control lever.
Clean all four couplers.
Connect to the matching color-coded couplers.
Install the coupler plugs into the caps to keep them clean.
(upbeat music)
Enter the compact tractor and start the engine.
Check the loader functions using the joystick control lever.
Slowly tilt the bucket forward
until the loader arm rotates into its mount.
Extend the loader arm cylinder
until the pin holes and the mounts are aligned.
Stop the engine and exit the compact tractor.
Insert loader arm retainer pins, and insert retaining pins.
Remove retaining pins and retainer pins from both stands.
(upbeat music)
Raise the stands fully,
and install the retaining pins through the stands.
(upbeat music)
Remove air from the hydraulic system prior to use
by raising and lowering the arms
and tilting the bucket back and forth.
(upbeat music)
The loader is now ready to use.
Grease all 16 fittings before using the loader.
(upbeat music)
Park on a flat, firm, and level surface place.
Place all controls in neutral.
(upbeat music)
Tilt the bucket forward.
Lower until cutting edge is on the ground.
(upbeat music)
Stop the engine and exit the compact tractor.
(upbeat music)
Remove retaining pins and retainer pins.
Fully lower both support stands.
Align with bracket holes and install both retainer pins.
Install a retaining pins.
Remove loader arm retainer pins.
Store in a safe location.
(upbeat music)
Enter the compact tractor.
Tilt the bucket back
until the support stands are firmly on the ground.
Slowly tilt the bucket down
until the loader mount raises off the compact tractor mount.
Stop the engine and engage the parking brake.
Relieve hydraulic pressure
by moving the joystick control lever.
Disconnect with the four couplers.
Clean any dirt or debris.
Install caps and plugs to keep dirt off.
(upbeat music)
Position hoses so they lay over the loader arms,
not on the ground.
Slowly back the compact tractor away from the loader.
Make sure hydraulic hoses
do not get caught on the compact tractor as it moves.
After the loader has been removed,
installed pins into the loader arm uprights for storage.
When starting the loader, grease all 16 fittings
and apply a light coat of grease
to any exposed cylinder rods.
(soft music)