hey everybody GEOARM security here and today we're going to show you how to
program the 2gig-dw10-345 into the all-new 2gig gc3
wireless home security and home automation system so the first thing
that we're gonna want to do is we're gonna remove the contact out of its
package which is very simple
go ahead and remove the mounting screws you want to remove the magnet and these
separate external contact wiring mechanism as well as the sticky tape
your instructions and the actual contact here
alright so what you're going to do is first off you're going to go ahead and
open up the contact by pushing down on this depression and then you're going to
separate the front plate from the back plate like that and you'll notice
there's a little battery saver here you wanna go ahead and pull those out from
underneath make sure the batteries are still in their good so now the batteries
have some juice next you want to locate the little depressions here and the hooks go
ahead and seal that contact backup take the magnet of its content package
your contact and your magnet first thing you want to realize there's three little
notches here which is the actual reed switch 123 and then you have your magnet
here with a little arrow she wanna make sure those lineup though the first thing
that you can see it actually is that an actual think it's very thin its
aesthetically it's a very nice contact it's not too hard on the eyes now to
program the 2gig-dw10-345 with an instant perimeter setting from
the home screen on the 2gig go ahead and select the 2gig logo default installer
code is 1561 to get you into the
programming area select System Configuration wireless zones and we've
already programmed the one and two so we're gonna go ahead and start
programming wireless zone 3 select sensor type you can go ahead and select
the hamburger button to go down to perimeter or you could just put 03
continuing on select the down arrow Equipment Code 2gig thin door window contact
086 to select down serial number this time I'll go ahead and show you how to
manually enter it in so you would take your contact you locate the serial
number here and you'll see it's the TX IDs so it's 0726 127 now you can select
the down arrow equipment ages new sensor loop so when you enter this in manually
the serial number in manually need to make sure that you select loop 2 go
ahead and select the down arrow transmission delay we want disabled that
means you will not have the five seconds to disarm the system before it actually
sends a signal to our central station so select down Voice descriptor will go
ahead and use side door and select Done continuing on sensor reports enabled
absolutely if you wanted to send signals to the Central Station select down
sensor supervision of course you like the panel to constantly check in with
this device to make sure that is within distance sensor chime will go ahead and
mix it up a little bit we're gonna put chime to with voice if your gonna go
ahead and program and others don't you can select Next zone we're gonna stop
here for right now we're going to select return to system configuration
back arrow review all the changes that you've made select Save and will make
sure that it is programmed into the system
side door so we know it is programmed in there now will check to make sure
that it is on that instant perimeter by selecting arm away everything away
exit now all right you can back out and that's how you program the 2gig-dw10-345
with an instant perimeters setting into the all new 2gig
gc3 wireless security and home automation system please make sure to
subscribe to our YouTube page and you our blog at DIYsecurityblog.com if you
need to reach us by phone our numbers 1877 443 6276