Hi everyone, welcome back to geardo.
Today we will show you how to replace the power & Volume flex on the iPad 8 Gen 2020 10.2 model,
Before Starting, we need to have the right tools to proceed with the repair,
which You can find in the description.
Proper heating is required to separate the screen from the body for tablet repair. For
this, we use a heating pad designed for tablets and mobile phones. On iPad 2020,
make sure to heat the front side. Select the Tablet heating option and leave it till
the heating completes. Alternatively, you can use a heat gun or hairdryer.
Once the heating has completed, use a suction cup on the sides to lift the front screen.
In between, Insert a Plastic Card pry tool or triangle picker and cut the adhesive around.
Be gentle while pulling; there are flex cables attached to the logic board.
To lift the touch screen, take the direction like opening a book,
but from the left-hand to the right-hand side.
Open and place it like an open book till removing the LCD Screen.
Next, take off the LCD screen by undoing screws;
there are sticky tapes are covering the screw heads; move aside and remove four screws.
Next, lift the screen to 90 degrees by the top and
disconnect the plug by undoing three screws and the shield.
The shield is missing from this device, but your device should have it.
Next, unplug both touch screen connectors by the socket,
peel the tape, and raise the tab to take the touch ID connector plug.
Now the Touch Screen unit can leave from the body.
Next, on the top-right, take off the shield by undoing three screws.
Next, On the top right, release the connector plug by moving the adhesive.
Next, undo two screws on the volume plate shield and two more screws on the power button.
And then take out the volume plate shield.
Next, gently take out the broken flex from the power and volume sockets by using a tweezer.
Next, place the new power & volume flex on the board and secure the connector.
Ensure the placement and secure the volume shield by adding two screws and then the power button
by securing two screws. Make sure to put the adhesive on top of the power & volume connector.
Next, secure the shield by adding three screws.
Next, secure the touch screen assembly plugs and the Home button flex.
Next, Place the lcd screen and secure the
connector. And then add the shield by inserting screws.
Next, insert four screws to secure the screen.
Next, to clamp up the iPad 2020, first ensure it has enough glue on it.
If not, you can use B7000 glue or Double-sided pre-cut adhesives.
Take the closing book direction and place the digitizer on the body.
Place the bottom section first, follow the top,
and click sides and the bottom simultaneously. Make sure to put
pressure on the frame sides and verify that the home button sits and clicks precisely.
Here, we are using screen bonding clips to tighten the screen to the frame. If not,
you can use rubber bands and leave them for some time.
hope you have enjoyed the Replacement guide
Let us know if you have any questions; please like, share, and comment on our videos.
Do not forget to hit the subscribe button.