Hello everyone today I gonna show you how to replace front camera on iPhone 7 Plus
What tools you will needed to disassemble the iPhone 7 Plus:
Screwdriver set Plastic mediator
Tweezers Suction cup for removing display
Adhesive tape for restore water protection Hairdryer
In the description under the video, I left links where you can buy all the necessary
tools and replacement parts for the iPhone 7 Plus
Turn off the iPhone and remove the SIM card tray.
Remove the two screws near the charging port with a Pentalobe 0.8mm screwdriver
Take a hairdryer and heat the display surface for 1-2 minutes.
Set the suction cup near the home button and pull up the ring.
Next, take the plastic mediator and begin to disconnect the display from the case of iPhone
On the top of display, inside there are two latches that attached to the case, so you
need to pull the display down and unstick the display from top.
The case of iPhone 7 Plus opens like a book, that is, open the display to the right.
Now take a Tri-Wing 0.8mm screwdriver and remove 4 screws on the lower metal panel and
3 screws on the upper metal panel.
First, disconnect the battery cable from the mainboard and after disconnect three display
cables.
To replace the cable with the front camera and sensors, you need to unscrew 5 screws
and remove the metal bracket.
Now remove the ear speaker.
Next, move on to removing the cable with the front camera and sensors.
The cable is glued to the display case and it is recommended to heat the backside of
display with a hairdryer for successful peeling off cable.
Take a thin, but not sharp tool; it is best to use tweezers with flat ends and start peeling
off the cable first, and then the sensors.
In the description under the video, I left link where to buy a cable with a front camera
for replacement.
Install a new cable with the front camera.
Install the ear speaker.
Put the metal bracket on top and fasten 5 screws.
Everything assembled, now you can connect and check how the front camera works.
Please note that first 3 display cables are connected, and lastly a battery cable.
If the front camera and sensors are working fine, you can begin to the final stage of
assembly with restoration of water resistance.
Remove the adhesive tape from the back cover of iPhone.
Now take a cotton swab and medical or isopropyl alcohol, and wipe the iPhone back cover from
the remnants of glue.
Now take a waterproof adhesive tape and put it on the iPhone case.
Using this adhesive tape, you restore resistance to dust and water.
First, connect three display cables to the mainboard of the smartphone, and then connect
the battery cable.
Install metal panels and fasten the screws.
Turn the display over and push it to the back cover.
Fasten the last 2 screws near the charging connector.
Install the SIM card and turn on the iPhone.
I hope this video was useful to you and helps repair your iPhone 7 Plus.
See you soon on HowFixit