you
these are speeds ups we have the
imperial set there on the metric set
these are made by a Canadian company and
these enables you to tap holes that have
been drilled very quickly indeed take a
look at the m12 version though you can
see that that is very well made that is
made from m2 steel which is nitrates
courted the ex agonal head is exactly
the same size as what you would use for
the bolt so if using an m12 that as a 19
millimeter head which is the same as an
m12 bolt so the others make them
extremely fast you can swap from the tap
to the bolt very quickly indeed using
the same size socket that goes for all
the other sizes as well I'm going to
start off by trying the six millimeter
speed tap this is quite an inch steel
and I have to do all the correct size
pilot holes in there ready for it to be
tapped
I want to spare some drilling and
tapping fluid onto the top before we
start then I'm going to proceed to tap
one of these holes you can see just how
fast that was that was absolutely
incredibly quick so we can now simply
tear that out we can then take another
six volt start out in there and we can
drag that in using the same socket so
these were absolutely incredible idea
these are so fast I'm not going to try
the m8 tap on these holes which I've
been drill to the correct size
[Music]
say that is incredibly quick just
demonstrate that again this time I'm
going to try out the m12 speed up to
make it a bit more difficult I'm using
some 10 millimeter thick steel plays
I think you'll agree that was very
impressive these are very quick one of
these should last for about 200 holes so
they will last a very long time you can
actually use these on thicker material
should you wish to do so but you should
really use a spanner instead of using an
impact wrench