Hey guys, in this video you'll find the installation
of the Gyro brake system on a GT BMX bike
The Gyro brake system includes the upper and lower cables, plates, bearing, u-brake
cable hanger and adjusting barrel
Put grease to the frame fittings
And then install the u-brake
Before tightening the bolt, you need to preload the spring tension
Hold the outer fitting by using a 13mm wrench, turn it clockwise and then tighten the bolt
Do the same thing on the other side
Remove the stem and install the plates, bearing and upper cables
The lower plate is already installed on the bike
so all I need is to put in the bearing unit and then the upper plate and cables
Insert the barrel
And finally, install the lower cables and connect the u-brake with the cable hanger