Required tools: All-purpose cleaning spray Square oil drain plug socket No.8 Drive socket # 27
Ratchet wrench Torque wrench Oil drain pan Funnel
Flat Screwdriver Microfibre towel Fender cover
1. Unscrew the oil filler plug.
2. Unscrew the filter housing cap together with the old filter element. Use a drive socket #27.
Use a ratchet wrench.
3. Put the old oil filter in the container.
AUTODOC recommends: Move up the container. The oil starts to drain out of the drainage hole immediately after you have removed the oil filter.
Cover the oil filter housing with a microfibre towel to prevent dirt and foreign objects from getting into the system.
4. Lift the car using a jack or place it over an inspection pit.
AUTODOC recommends: The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point. All work should be done with the engine stopped.
5. Put a waste oil container with at least 4 l capacity under the drainage hole.
6. Unscrew the drain plug. Use square oil drain plug socket No.8 Use a ratchet wrench.
7. Drain the used oil.
AUTODOC recommends: Caution! The oil may be hot. Wait until the oil has completely drained from the drainage hole.
8. Detach the oil filter from the filter cover.
9. Clean the oil filter housing cap. Use all-purpose cleaning spray.
10. Remove the oil filter cover O-ring. Use a flat screwdriver.
11. Install the new oil filter to the mounting seat on the filter cover.
12. Install a new O-ring to its mounting seat on the filter cover.
13. Lubricate the rubber seal of the new filter with a little amount of fresh oil.
Please note! Make sure to install the filter correctly. Don't mix up the sides of the part.
Wait until the oil has completely drained from the drainage hole.
14. Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray.
15. Screw in the new drainage plug and tighten it. Use square oil drain plug socket No.8
Use a torque wrench. Tighten it to 30 Nm torque.
16. Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray.
17. Lower the car.
18. Screw the new filter into its place.
19. Install a new oil filter housing cover and tighten it. Use a drive socket #27. Use a torque wrench.
Tighten it to 25 Nm torque.
20. Remove the oil filler cap. Insert the funnel.
21. Pour oil into the engine through the filler. Required amount of oil: 3.5 l.
AUTODOC recommends: Use the oil recommended by the manufacturer.
22. Check the oil level using the dipstick. Top up oil if necessary.
Please note! The oil level should be between the Min and Max marks.
23. Install the oil filler cap. Tighten the oil filler cap.
24. Run the engine for a few minutes. After the oil pressure warning light goes out, stop the engine.
25. Check the oil level 5 minutes after the stop of the engine operation using a dipstick and add oil if necessary.
Please note! The oil level should be between the Min and Max marks. Make sure that the oil filler cap is properly tightened.
Check the threaded plug of the drainage hole and the oil filter seal for tightness. If necessary, carefully tighten them up.
Note that oil pressure warning light, which indicates insufficient pressure in the lubrication system, may be on for a longer time than usual.
After a few seconds, the oil will fill all the channels, and the light will go out.
To protect the environment from pollution, be sure to dispose of the used filters at special collection points.