The Advance Termite Bait System is the next generation of termite baiting.
This preventative termite control system is designed to be installed around the outside
foundation of your home. Preloaded with a Termite Inspection Cartridge and Termite Monitoring
Base, the stations allow you to intercept and monitor for termites that come in from
the yard to infest your home. At DoMyOwn.com you can find the Advance Termite
Bait System as individual stations, or in our Termite Baiting Kits. These kits include
the stations, a spider tool to open the stations, and Trelona bait cartridges to treat when
termite activity is found. If you already have termites in your home,
this system will not work to control that infestation. The termites will not leave your
home, where they have already found their food source, to go back to the stations. An
active termite infestation in your home should be treated with a liquid termiticide product,
and the Advance Termite Bait System should be installed to monitor for future termite
activity. After installation of the System, the Inspection Cartridge can be replaced with
a Trelona Bait Cartridge when termite activity is found in the stations.
Each Advance Termite Bait Station features vertical slots that maximize wood-to-soil
contact creating an ideal environment for termites. Inside each station is a wood monitor
and a Termite Inspection cartridge. Termites will start feeding on the wood base then feed
upward to the Puri-Cell monitoring tablets in the Termite Inspection Cartridge. The combination
of the wood base and cartridge makes it easy for you to inspect and detect termite activity
in your stations. Before you begin placing the Advance Termite
Baiting System in the soil around the perimeter of your home, here are three key things to
keep in mind: First – stations should be installed 2 to
4 feet out from the foundation of your home, either inside or outside the gutter dripline.
This is to ensure the gutters do not flow directly into your station.
Second – Stations should be placed 10 to 20 feet apart from one another, but they are
most effective when placed no more than 15 feet apart.
Third – Be sure to wash your hands and wear clean gloves before handling the Advance Termite
Bait Stations. Termites are sensitive to scents and would be able to detect any chemical or
cleaning product residue that may transfer from your hands to the stations, possibly
reducing the effectiveness of the system.
To install the Advance Termite Bait Station, you can use a shovel, post hole digger, or
auger to dig a hole 9 inches deep. By extending the hole 3 inches deeper than the station,
you allow an area for water and rain that drains through the soil and the station a
place to go without puddling inside the station. If water puddles or stays inside the station,
the wood monitoring base can become moldy and reduce its attractiveness to termites.
If the hole is just large enough for the station, remove any dirt from the hole, insert the
station and press down until the top of the station is flush with the ground. If the hole
is slightly larger than the station, place the station against one side of the hole you
dug flush with the ground. Then, fill in with dirt around the side of the station and pat
down the dirt to hold it in place.
You should check your Advance Termite Bait System stations every 3 months, or quarterly,
for termite activity. To open the Bait Station, you’ll need The
Spider tool. Place The Spider station access tool over the station cap and rotate counter-clockwise
until the two locking tabs clear the locking ring. Once unlocked, the station cap stays
in The Spider and can be lifted away. The cap can be replaced by locking it in place
with the Spider Tool. When the station is unlocked, you can inspect
the monitor for termite activity. Again, make sure you wear gloves when handling the cartridges
or station to minimize your contact. A cotter pin puller with a curved tip makes it easy
to pull the cartridge out, check for termite activity, and put it back in without having
to touch it. If you notice termites or signs of termites
in your stations, the Termite Inspection Cartridge should be replaced with a Trelona Bait Cartridge.
Trelona cartridges contain an active bait to help control termite colonies.
The Wood Monitoring Bases and Termite Inspection Cartridges should be replaced every 12 months
for the best results. Wood that is soggy or moldy should be replaced as soon as possible.
And it’s that easy with the expert help from DoMyOwn.com. Don’t forget to subscribe
to our channel for more DIY and product videos.