Hi everyone, welcome back to geardo.
Today we will show you how to replace the battery on the iPad Pro 10.5 2017 edition.
Before Starting, we need to have the right tools to proceed with the repair,
which You can find in the description.
The most vital part in iPad repair is Proper heating. For this,
we use a heating pad designed for tables and mobile phones. On iPad devices,
make sure to heat the front side of the iPad. Select the Tablet heating option and leave it
till the heating completes. Alternatively, you can use a heat gun or something similar.
Once the heating has done, use a suction cup on the sides to lift the front screen.
In between, Insert a couple of Plastic Card pry tools and cut the adhesive around.
Be gentle while pulling; there are flex cables attached to the logic board.
Once the separation has completed,
slightly slide up from the bottom and lift to 90% degrees from the top.
Next, undo two screws
to pull out the shield, and then undo four connector plugs
to remove the front screen assembly unit.
Next, undo the screw on the battery connector.
Next, undo ten screws and take out the logic board shield.
Next, undo four screws on the charging port.
Next, Undo four connectors on the top end of the logic board.
Next, undo two antenna heads from the board and then loosen
adhesives to disconnect the left & right speaker plugs.
Next, apply little heat to soften the glue on the logic board and the battery.
For this, we are using a heating pad, but on the rear side.
Next, gently using a card pry tool, cut the adhesive under the board.
Next, slightly insert a pry to lift the board.
Next, using a pry tool, cut the adhesive under the board.
Extremely gentle in this process and lift the board slowly.
Take out the logic board and then, using a pry tool cut the adhesive under the battery.
The glue under the battery is strong, and it will take some time to cut the adhesive.
While lifting, loosen the adhesive from both sides.
For the replacement, always seek a good branded one or an original battery.
Next, place the battery in the body with adhesive. And also, place the speaker adhesives.
Next, Gently place the logic board in the body, First, slightly insert the charging port to the
body and ensure the placement and move cables aside before securing the board in the body.
Next, secure five connector plugs to the board.
Next, connect both speaker plugs and place adhesives.
Next, place both antenna heads on the board.
Next, place the board shield by adding ten screws.
Next, secure the screw on the battery connector.
Next, add four screws to the charging port board.
Next, Place the LCD assembly unit in the body by securing four connector plugs.
Keep the screen to 90% from the bottom and start connecting plugs.
Make sure all connections are secured, and then add the shield by inserting two screws.
Next, Before clamping, it is good to verify the screen functionality and then secure
the screen to the body by adding adhesive. You can use b7000 or double-sided adhesive.
Place the bottom section first, follow to the top,
and click sides and the bottom simultaneously. Just make sure to put pressure on the frame sides
and verify that the home button sits and clicks precisely.
Next, we are using screen bonding clips to tighten the screen to the frame.
If not, you can use rubber bands and leave them for some time.
Hope you have enjoyed the screen Repair guide.
Let us know if you have any questions; please like, share, and comment on our videos.
Do not forget to hit the subscribe button.