welcome the following video will demonstrate how to add a new smart z-wave device to a 2gig
edge security system to add a smart device to an edge system begin by tapping the settings icon
next you'll want to enter your installer code
the settings menu will display and you'll want to scroll to the bottom of the screen
tap installer toolbox then tap z-wave settings the z-wave settings menu will display on screen select
add device and then tap the add device button located in the bottom right corner of the screen
next you'll see a pop-up message on screen which reads initializing please wait
once the message changes to read listening follow the smart device's manufacturing instructions
for putting it into add remove mode the panel will then locate and connect with the device if
you're adding a z-wave device with s2 security the panel will prompt you to use the on-screen
keypad to type in the device's dsk or pin code refer to your smart device's user guide
for information on where to find this code once you're done adding the code tap the enter button
note this screen will only appear if you're adding a z-wave device with s2 security next
your panel will display a series of pop-up messages while it adds the device once the
device is added you'll see a success message tap the done button to close the success message
you'll then see a few more pop-up messages appear on screen as the panel finalizes the process
next you'll see the device details on screen at this point you'll want to rename the device
to rename the device you'll need to tap the edit icon next to the device details
you can then use the on-screen keypad to type the new name for this device
once you're done typing the new name tap the save button located in the bottom right corner
of the screen lastly you'll want to tap the done button to finish programming the z-wave device
here's a troubleshooting tip if you're not able to add the new z-wave device to the edge system
there may be old programming still on the device as a result of factory testing in this case
you'll want to remove the device first and then re-attempt to add the device
to remove the z-wave device settings first tap remove device then tap the remove device button
located in the bottom right corner of the screen you'll then want to wait for
the initializing pop-up message to go away once you see the listening pop-up message
follow your device's manufacturing procedure for putting it into add remove mode when the device is
successfully removed you'll see a success message on screen tap the done button to close the message
then tap the done button in the lower right corner of the screen to return to the z-wave settings
screen you can then tap add device and repeat the steps we discussed earlier in this training
add the rest of your z-wave devices using the steps we just discussed
once you're done adding and installing all smart devices
you'll want to run a network rediscovery to run a network rediscovery tap rediscover network
and then tap the start button once the rediscovery process is complete you're all set
repeatedly tap the back button until the home screen displays
congratulations the new smart device has now been added to the 2gig edge
system make sure to subscribe to our youtube page and click the show more tab underneath the video
where you can view valuable links pertaining to this product
similar how-to videos and our low-cost no contract alarm monitoring services