It didn't happen again
The hook did not pick up the thread
Hello Friends
in this video you will see that
The hook, 90 percent of the problems
in the sewing machine.
to correctly set when you watch all of the video
and resolve the fact that this is a problem
when you grasp this seam logic too
it will be easy
You will be able to do these works easily
and you will be the master of your own machine.
when the hook setting is out of order,
the sewing machine jumps thread
it does not sew, skips the thread, does not take the thread,
it sews straight , it does not sew zigzag,
it sews straight, as soon as the hook is not sewn
the needle makes a noise,
it bends the needle or breaks the needle
it peels the thread, it breaks the thread.
The solution to all these problems is the hook,
Friends, for this to reach the hook
we need to remove the shuttle bearing by removing the plate .
I also took a video of the disassembly and assembly of the shuttle bearing.
You can also watch it if you need to.
As for our machine,
when we turn the handwheel, the hook does not turn at all.
This machine does not sew.
There is a simple reason for this, and it can happen to us often.
That is the loosening of the hook pulley
These screws may loosen over time due to vibration.
The fabric is stuck in the hook, the pulley is forced to turn, it scrapes the shaft, it can loosen like that.
If we are already at this stage, we are at zero right now. We will adjust the hook step by step.
First, we look at our needle.
Needle our skewed or end has been broken when we look at
we need a new needle
we will see a space on the needle
hang-up the needle in the right direction
the needle when inserting the flat side should face facing the needle tip where we will see a notch friends, here is a notch
this notch for the hook
had the needle in all needle has been left.
The hook will take the rope from here.
When and how will it get it.
Friends, this is what they call hook adjustment, what they call time adjustment.
So how do we set it up?
The hook takes the rope at the right time and in the right place
First, If the screws are tight we will loosen them
the hook will be returning idle
Now I'm actually move up and down the flywheel turning the needle
and the needle while in the down position, let's stop
the flywheel can catch the time by slightly turning the needle go up
the flywheel will come up a little more trans the needle. We are at this point.
Now let's leave the flywheel like this.
Let's turn
our hook, the tip of the hook will be behind the needle, on that notch on the needle,
let's tighten the pulley screws while the hook is in this position.
Friends, this point is the point where the hook takes the rope.
If we cannot provide this position, for example, if the needle stays up
it does not pick up the thread , sometimes it does not, sometimes it does not, it skips
It sews straight , does not sew zigzag, does not sew straight again, does not sew with a pattern.
If the needle remains down, the hook may hit the needle
a noise comes from the needle, it bends the needle, it breaks the needle
It peels the thread and cuts the thread
Even though the hook part or shape is different in different brands and models of sewing machines,
the logic of this is the same. When you understand this logic, you can do it on all machines.
I hope it was helpful. If you have any questions, you can write them in the comment section.