Welcome to Sage Audio. Today we’re covering How to Mix Vocals in FL Studio. But first,
If you have a mix that you need mastered,
send it to us to receive a free mastered sample of it with the link in the description.
Equalizing Male Vocals
For these first 6 chapters, let’s work on a vocal recording from a male singer,
and use only stock plugins.
I’m going to start with an EQ, with which I’ll use a high pass up to
right before the fundamental. Then I’ll use a bell to balance the area of the low-pass’s cutoff,
use 2 bell filters to boost the fundamental and vowels respectively, and dip some nasal tones.
Lastly, I’ll boost a higher-order harmonic above 2kHz to increase presence,
and then add air with a shelf at 20kHz, and a Q value that decreases the band to unity by 10kHz.
Let’s listen to how these curves clarify the vocal.
2. Multiband Compress Male Vocals
Next, I want to compress the vocal, but since FL Studio offers this convenient MB compressor,
I’ll use it as opposed to a typical one. I’ll compress the lows and mids,
and use the high band to de-ess my vocal, which for male vocals should be around 7kHz.
I’ll achieve a few dB of attenuation on each band and set the release for each
band to right above what would cause distortion to the waveform - so above 50ms for the lows,
40ms for the mids, and 10 for the highs.
Let’s listen to the vocal with controlled dynamics and de-essing.
If you’re enjoying the video, hit the like button; it helps us bring you more videos
3. Using Maximus on Vocals
Since the male vocal’s fundamental is low, first, I’m going to lower my mids
to separate the processing on my fundamental and 2nd order harmonic. I use the same technique for
my release that I used in the last chapter, and then very subtly increase the midpoint.
This will increase the volume of each band from the noise floor up, but in a tasteful way,
since it’s only being increased slightly. Lastly, I’ll add a little saturation in to fill the vocal.
Let’s listen and notice how the vocal has more detail.
4. Fruity Delay for Thickening
I’m going to use this delay to thicken my vocal before reverb, so I’ll set a quick delay under
10ms, use moderate feedback, and isolate the reflections to below 5kHz. Then I’ll introduce
subtle modulation to make it more complex, and reduce the wet output to blend the effect.
I also add some saturation to the delay taps to increase harmonics and control their dynamics,
making them easier to hear.
Let’s listen and notice how it thickens the vocal.
Only a small percentage of people that watch our videos are subscribed, so if
you’re enjoying the video consider subscribing. It’s free and you can always change your mind.
5. Fruity Reverb on Male Vocals
I want to use this reverb both stylistically and practically,
so first, I’m going to increase the pre-delay to let the transient of my vocal though,
which retains intelligibility. I’ll increase the room size to my preference,
introduce very subtle modulation, and isolate the reflections to right above sibilance.
With early reflections, I’ll make the vocal sound denser, similar to the delay from our last
chapter. The more stylistic sound comes for the wet signal, which will be the longer reflections.
Let’s listen and notice how this reverb gives the vocal a pleasant sound,
and an identity that’s unique.
6. 3-Band EQ and Parallel Processing
Last up for the male vocal demonstration, I’m going to use this 3 band EQ at the end of my chain
to shape the vocal. I want to dip some of the lows and balance the mids,
but also, bring some clarity and air out with the high-frequency shelf.
Then, I’ll use these wet/dry dials to the right of each insert to blend the effect in,
essentially creating parallel processing.
Let’s listen to the full before and after of the processing we created.
7. Equalizing Female Vocals
For these last 4 chapters, let’s use the same processors we used for the
male vocal recording, but adjust them to accommodate a female vocal performance.
Starting with EQ, you’ll notice that the high-pass is situated higher - this is due to a higher
frequency fundamental for the song, which will usually be the case with female vocal recordings.
Similarly, my fundamental bell, vowel bell, nasal tone cut, and presence will all be higher.
The air frequencies will stay the same, but as you can see,
higher pitch singing results in higher frequencies we need to pay attention to.
Let’s listen to how this curve affects the vocal.
If you're enjoying the channel, join the community with the link in the description.
8. Multiband Compress Female Vocals
Next, I’m going to use the MB compressor in a similar way to chapter 2,
but make some changes due to the higher frequencies being sung. First, I’ll want
to increase the low band, so that my fundamental and 2nd ordered harmonic are processed separately.
Then, I’ll set my releases to 30ms, 20ms, and 10ms to avoid distortion. Since the
frequencies are higher, we can use a faster release time without distorting the waveform.
Let’s listen to the vocal with controlled dynamics.
Maximus on Female Vocals
Again I’m going to use Maximus to increase the detail of the vocal, but this time shift
the bands upward and affect the release times as we did in the previous chapter. This vocal
has a little too much transient, so I’ll enable linear phase mode, which reduces them slightly.
Although a little unorthodox, you can use any linear phase mode on a somewhat sharp vocal
to smooth out the transients due to the delay compensation needed to make it work.
Let’s listen and notice how the vocals become more detailed,
and in this case, a little smoother with linear phase enabled.
Delay, Reverb, EQ, & Parallel Processing
Last up, I’ll insert delay and reverb just like I did in chapters 4 and 5 - you won’t notice much of
a difference between the temporal processing used on male and female vocal recordings.
I’ll use the 3 band EQ to dip lows, smooth the mids, and boost the highs.
Lastly, I’m going to listen carefully and blend in or out
any effect that I have too little or too much of - making it easy to find just the right amount of
processing now that I have the perspective of how the vocal sounds almost finished.
Let’s listen to the full before and after of this vocal being processed.
If you have a mix that you need mastered, send it to us to receive a free mastered sample of it
with the link in the description. Thank you so much for watching.