friends all a huge hello today to work with a profile pipe. In my
case, it was 40 by 40, they will make a piece of it, I will make one good
homemade product out of it, well, I’ll get just two pieces, what happens, let’s watch the video, let’s go,
marking a piece of 35 centimeters from the edge, retreating almost two centimeters
on the other side, we do the same, from one edge to our mark, right
here, do the same
, as a result we get two such pieces and these two plates, they will
also be useful to us, our cosmo girls, too, but now we’ll draw a little now, we’ll find
it, but we’ll do approximately the center like this and here I’ll take the retreat the rope of centimeters and
also immediately from this side we will also make the center and
something like this is retractable, too, the triangle
remade everything by eye for the plates, clamp it in a vise and with the help of a refusal
, we would get such a triangle, personal hell, cut off a little bit,
which detail I twisted a little, too, everything cleaned out I need to make two holes
dita pennies ready now I offend them
2 already painted assembled in the form of the product has dried up, now you need
to assemble it, start collecting heat shrink points
, the bicycle tire
immediately figured out the excess, I
also cut off everything well, degrease the gasoline like this and use a universal
two-component glue and apply a little of it on one side that the spray can confirm from
another country, we act in the same way,
we take five screws and install them through the washer and
tighten them well so that you could move, of course, you could buy self-locking nuts, but
I didn’t have such and why was it necessary to spend money, I honestly do it with glue, I’ll
dig a little here and there,
everything is now about and it will harden and here it already turns out the nut is not it will unwind
with us to relax, our material will not be everything our girl herself is ready 2 assembled according to the same
principle everything is exactly the same, but only now I wanted to show shrinkage from non-tarmo,
we take electrical tape, of course, what was needed from the graveyard is blue, but unfortunately I have it at hand
it didn’t turn out before we will use what we have and wrap it well we ’re
ready like this very two pieces of us are ready now we’ll see what they’re here for, of
course, maybe already and knows someone maybe suggests so then write comments
friends on except for sho then we’ll get great rod holders saw
it myself I’ll demonstrate everything is holding well and the fishing rod of your units is not needed for any bulky
devices these two buns fit in the usual offset you can what kind of museo case, that
is, yes, I can now show you we take it into the fishing rod and in any position
it costs more in the eye not disassembled in a state of going quickly also understands quickly
understands that the rubber bands were made in order not to spoil the rods the handle everything is fine the
rod is heavy + the counterweight reel is good everything holds perfectly friends but I hope the video
was useful to you and because you liked the hurt for the souls of someone about nostalgic about that what I saw
this invention and in the picture it was done back in the USSR, I don’t know why they stopped now to
do this they began to do it cumbersome these are rings and they understand but of course they did it honestly
if you liked this episode be sure to thumbs up don't forget to subscribe to the channel
I'm waiting for feedback from you I wish you all good health until we meet again bye bye