I got this picture printed out years and years ago.
It's from where I grew up and in this video I'm finally gonna make a frame for it.
I rough pre-cut this cut here on the band saw
because this piece is only long enough if I fully use both pieces.
And this way I can kinda see how its gonna work out.
If I hadn't pre-cut that like that once I cut the molding
I have to cut the miters like that. And at that point it wouldn't be long enough
for both sides anymore.
I'm thinking I should add a bevel to the inside edge here
to make it taper in towards the picture but
the other idea is to just take these pieces of wood
and bevel them like this.
And that just means cutting a bevel on the back.
And I need to decorate this profile a little bit.
And I'll do that by cutting a cove like this on the table saw.
Here's the cove cut without any sanding yet.
It came out very clean because, as usual, I have a trick up my sleeve.
So, two things I did is I tilted the blade this way a little bit
so as I'm feeding this way I'm feeding into the top of the teeth.
The other trick is I started with a junk blade
and actually rounded the tops of all these teeth
by grinding away the alternating points.
It looks fairly nice so far but I want some kind of visible edge on this frame.
My thinking is I want some kind of sharp edge here.
So, I'm thinking I'm gonna cut in like this and then
a curve like so. And I'll try to approximate that with the table saw.
With just a few cuts in the table saw
that already looks like a convex round.
But it actually has corners. And I'll try to smooth those over with a hand plane.
With a ledge cut for the picture I'm ready to cut miters into these.
And for that purpose I built myself a miter slide.
Well, that looks like it's gonna work good.
Now I just have to glue it together.
I made these picture frame clamping claws many years ago.
And by clamping these to the edge of the frame
I can concentrate on getting just one joint
at a time lined up perfectly.
Now I just gotta do that with glue.
And the last two joints I have to do at the same time.
So I set up on the table saw so I can get at both ends easily.
Next its time to cut some reinforcing splines into here.
And for that I'm just gonna use a plywood box on my table saw sled.
I still need to clean up these splines. And I'll clean those up
by cutting a back bevel along the edge using this fence set-up.
For the glass for this picture frame, I'm gonna use old storm window
that I got from the garbage.
Shit!
As long as I manage to not let this crack get any longer.
I can still use this glass.
I got a nice little cavity for a screw head to really hook onto now.
I think a bit of a dark bluish tinge will go
well with that picture I have of the spring.
I giving this several coats of water-based Varathane.
And that will seal it give it gloss and protect the paint I just put on it.
I'm just gonna put some nails to hold the back plywood in.
It feels really manly pushing those nails in with my bare hands but
I did pre-drill the holes.
I am quite pleased with how this molding came out.
And it was done almost entirely on the table saw.
So I ended up drilling two holes in two studs.
And I put holes off-center in the picture.
So that way I could hang it off the studs.
And get it exactly where I want it.
And it doesn't go back and forth.