hello guys today we brought to you - 11 pro battery replacement it is very important to
turn off the phone before we start any repairs on the phone like any other iPhone we have to
open the bottom pentalobe screws after that very carefully and gently we will apply the
heed around the LCD because iPhone 11 Pro comes with a seal which has a decision between mid
frame and a LCD by applying the heat it will loosen up the stickiness and it will become
easy to remove the LCD from the frame after that we're gonna use a suction tool to create
a cavity for our guitar pick to start prior opening the LCD make sure when we are prying
opening the LCD with the guitar pick the guitar pick does not go in too much and it only cuts
in between that adhesive one successfully we have opened the LCD now we can start removing
the metal plate which is covering all the connectors we will open the five screws on it
it is always saved that if we remove the connectors from the motherboard of the LCD
and keep the LCD on the side out of the way while we are working with any other pairs in the form
now we are going to remove the safety plate of battery connector on the motherboard it
has two screws using plastic spudger tool we will disconnect the battery let's remove the
other metal plate from the bottom it has four screws as you can see it's very easy to remove
it will be out of the way and again use the plastic spudger tool to disconnect
all the connectors also it is important for us to remove this metal plate on the
side which is covering the charging port flex so we can reach the adhesive which is
under the battery use the plastic spudger tool to disconnect them
it's now we can reach the adhesive tape under the battery we start to pull it out carefully
slowly take your time patiently try to pull it because once you break here it
becomes very difficult to remove once those tapes are being pulled use plastic spreader
tool to pick it up because sometime you might have not completely able to remove the adhesive
from the battery never use any metal tool near the lithium batteries because they are
very easy to blast now simply reverse the whole procedure put the adhesive back on
the battery there is this way we can also put that easy cut them and put it in a way that in
future if you again want to remove the battery you're easily able to pull off that adhesive
push it down a little bit make it properly sit within the frame
start connecting all the connectors back
put all the metal plates important place whatever we remove from just
put them back make sure your charging port is scaled by the metal plate we have removed
put all the necessary screws and then put the metal plate which
was covering the battery connector with two screws
just reverse the whole method put all the metal plates and screws back on once you're done you
think everything is back safe on connect your LCD back carefully don't damage the flags just try
to put pressure on the connectors not on the cable and connect it back on the motherboard
now put back the metal plate with a mood put all the five screws back in
carefully bring the LCD back on the mid frame and work your way around slowly and steady push
it back in make sure it is sitting properly turn on the phone and check if it's working
I was working that's good but the bottom screws back on and that is it don't forget
to subscribe and like and share please let us know what you think see you soon