Hello everyone, today I show you how to disassemble iPhone 7 and replace the home button.
Unscrew two screws on the bottom of iPhone.
In description of this video, I left links to necessary tools for iPhone 7.
Display glued around perimeter of iPhone and we need to heat the surface of iPhone for
open it.
For this, I use a hairdryer because this will make it easier to remove the display.
Set suction cup on display near home button and pull up.
Use a plastic tool for separation phone case and display.
By easy and carefully moves, separate the display from iPhone case.
Pull the display slightly away from the top edge of iPhone to disengage the clips holding
it to the rear case.
Open iPhone by swinging the display up from the left side, like a book.
Remove the following four screws securing the lower display cable bracket to the logic
board by tri-point screwdriver
Remove two screws securing the bracket by PH0 screwdriver.
Use plastic spudger to disconnect connectors, but the first disconnect the battery connector.
Now you can remove the display module.
Remove four screws securing the bracket over the home button.
Pry under left edge of home button cable connector to disconnect it from its socket.
Next, gently separate the adhesive holding the Touch ID sensor cable to the backside
of display module.
Remove home button.
Let’s reassembly, first Install the home button.
Remove old glue from the phone case.
Now you can applying waterproof adhesive tape for iPhone.
Also I left link to this adhesive tape.
Connect all cables to the logic board and last connect the battery cable.
Set two cable bracket to the logic board and screw it.
Install display module to iPhone case and check elastic.
Set two screws on the bottom of iPhone.
Now we can turn on your iPhone 7