I have to fix my sighting I tried to save a little bit of money on my cable
bill by running an antenna I put it up in my garage attic what when I was
running my cord I kind of fished it in behind my siding and I Ava's cold out
and I gave it a little bit of a tug and it ripped my siding so sometimes trying
to save some money you know you waste some to that was unfortunate but today
I'm just going to change this little piece that's a little easier dirt from
this wait so what you do is gun snap so now i'm going to unsnap the bottom half
of this I'll start from this end too ok there's my cord let's not cut that I'm
going to measure the piece I have and cut in just a hair from it I'm just
going to use a carpet
and be careful please don't cut your self this it's recently tough thing is
if you're trying to do this when this is cold out don't do it you'd at least have
to get like that a hair dryer or something because if you start doing
this when it's cold out what's going to happen is it's gonna crack and you're
going to have more of a mess then you had before um and that's what i told my
wife when I did this in the fall and I never got to it I said that the wait
till gets warmer because I'm gonna break more signing I don't know is the end of
august and I'm just fixing this so I guess that worked ok now you will know
this but down here I'm going to have to cut this back as far as here so when it
snaps over you'll snap flush and sing with up here I'm going to have to cut
this cut this part of the lip off or vice versa so that it'll actually fit in
so we're going to mark this ok that's marked and this is marked so when I cut
that I cut this piece off and it looks like that so the other piece will stick
up on it and then you go to the back I am going to cut from the end make sure
you don't cut off the end so that should be good enough
the job is done my wife will be as happy as anything it only took 10 months to
fix the society I busted but I got it done the biggest thing is to make sure
it gets warm enough out you don't want to do it when it's cold because the
thing will just shatter the same reason is shattered when I was pulling on the
wire it's the same reason it was shattered when you turn on clipping so
make sure it's warm it up or if it isn't warm enough um ya have to fix it use a
prior to keep it up in