hi I'm Chris from Dynojet in this video I'm going to show you how to install a
Power Commander V on this Yamaha FZ-09 to install this unit we're going to need
to remove the seat the fuel tank in the airbox to get the seat off we will
unlock it from the tail section here
next we're going to remove some of the bodywork from the front of the tank
next I'll remove these panels from both sides there's one bolt and two plastic
rivets on the inside next I'm going to start loosening the fuel tank I'm gonna
remove these two bolts at the rear and I'm gonna remove these two bolts on both
sides at the front
now that the tank is loosened I can prop the rear of the tank up enough to
disconnect the electrical connector for the fuel pump underneath I'll need to
disconnect the high-pressure fuel line and there's two vent lines underneath
that I'll need to disconnect once those are disconnected I can remove the tank
next I'll need to remove the air box I'll start by unplugging the ECU I have
three hose clamps on all three of the throttle bodies that need to be loosened
and I have three bolts here here and here that I need to remove next I'm
going to disconnect this pair valve hose on the left-hand side of the air box and
I want to disconnect the crankcase ventilator from the bottom of the air
box now that that's all been removed I'm going to start installing my power
commander directly in front of the battery there is a black two pin
connector I'm going to need to plug my power commander in line with that my
module is going to store in this small compartment just in front of the battery
here I'm going to use a supplied velcro to secure the module in this compartment
the two pin connectors right at the module are going to plug inline with the
stock black two pin connectors in this location now I'll need to route the
ground wire with the small ring lug to the negative terminal of the battery and
right here at the negative terminal the battery I'm going to secure the power
commander's ring lug to the ground I'm going to route the rest of my Power
Commander harness just along the inside of the right frame and then across the
fuel rail right here on the right hand side of the throttle bodies I can find
my throttle position sensor I'm gonna unplug it
using the supplied posi tap I'm going to attach the single unterminated gray wire
on my Power Commander harness to the stock white wire on the throttle
position sensor connector I'm going to put the gray nut of the posi tap over
the stock solid white wire on the TPS connector I'm going to thread the
pointed into the posi tap onto the gray nut I'm gonna slide the red nut of the
posi tap over the gray wire on the Power Commander harness insert the gray wire
into the posi tap and thread the red nut down on top of it after making the
connection I can plug the TPS back in my next connections are going to go to the
fuel injectors they are underneath the black fuel rail a little bit difficult
to access I'm going to plug the power commander leads with the green colored
wires in line with the rightmost fuel injector the pair of power commander
leads with the yellow colored wires are going to go in line with the center or
the middle fuel injector and the power commander pair of leads with the orange
colored wires are going to go in line with the left fuel injector and that
will conclude all the connections of the power commander harness and now I can
begin to reassemble the bike