How to mix plaster guys carlite ultra finish here it's roughly about a full bucket of water
full bucket of water to a bag of finish a bag of plaster what you want to do is you
would rather be in a well ventilated area so that the dust isn't being breathed in but
if you are inside open the windows and the doors so you can breath also have your area
covered up so it stays clean you're not having to clean up after a lot after you just lift
the board and be done with it so i have my water in water always 1st and then powder
so i will build it up gradually probably put half in mix it then tighten it up from there
see it is very watery and then tighten it up from there slowly to get the constancy we
which I'm about to do a ceiling so i want it a bit thicker than you would mix it for walls
so thats at the constancy i want so you need to start cleaning the edges scrap of all the
powder and dust get it well scraped down low and pull it into the middle
make sure when you're mixing go round the edges and down deep to the ground of the bucket
another quick scrap just to be sure its is important guys to use clean water with your mix and clean
buckets clean mixing drill you dont want any lumps and stones in the plaster also dirty
water and dirty buckets can affect your plasters setting time and performance another thing
is wear old cloths so you're not getting stinking one more spin and thats it ready
tap of the drill
quick spin
that will clean the most of it
and then quick scrup guys down the shaft
spotless
better doing that after every single mix guys.