I'm going to show you how to install a corner rotating basket set into a 900 mil corner
cabinet.
You'll need a few tools for this.
You call this drill, some drill bits and some marking equipment.
Knee pads are optional but you will be working on the floor.
Normally in the 900 mil corner base cabinet, the shelf will be installed.
This will need to be dropped to the bottom of the cabinet in order for the carousel to
be fitted.
We'll remove the shelf supports and secure the panel to the bottom.
First of all, I'll just have to pre-drill a few holes and then screw the shelf down
with 28 millimeter screws.
So now we'll need to start and set up some measurements.
Ideally your benchtop would be in place and for the purpose of this exercise, we will
put one on top.
But remember, this corner cabinet is going to be installed with the benchtop in place.
So all your measurements and fixings will have to be done with the benchtop in place.
For the purpose of the video, we'll measure out the bottom first before we put the top
on.
Always refer to your instructions.
I'm measuring from the front edge of the cabinet for the placement of the pole.
So I'm just going to join up those marks that I've made and where the two lines intersect,
that's going to be the center point for the pole.
And now we'll do the same on the top.
For the purpose of the video, I've had to put a benchtop on temporarily.
But all the measurements that I've done on the bottom, I've transposed onto the top.
We've measured everything from the front edge, top and bottom, so all the measurements will
be identical.
Therefore, our fixing point's going to be round about here.
The next step we need to do is drill a 5 millimeter hole, where those two lines intersect on the
base.
That would then allow this locating pin to slot in and we can fix that to the base.
When you're drilling into a plastic fitting, just drill slowly and bear in mind that the
pressure of that could actually crack the fitting.
You'll notice that the bracket fixing for the top is slightly different to the one on
the bottom.
But it will still locate in the center where those two pencil lines crossed.
With this bracket, we also need to pre-drill.
It is with the smaller drill bit but everything's outlined in the instructions.
So now we'll start to install the basketware.
It is going to be a little bit fiddly, so if you're not sure of anything, always refer
back to your instructions.
Just to make the whole process easier, it may be better for you to build this unit outside
of the cabinet so you know exactly how it's going to fit together and which pieces go
where.
So we'll do that as well.
This is the basket mounting cap.
This must go on as well.
Then we can put another basket in, followed by the final cap.
All these things will be adjusted once it's in place.
So now you've had your practice run, let's do it inside the cabinet.
We now need to extend the center pole and locate it into the fixing bracket, and then
secure it again.
Now it's in place, ready for adjustment.
You'll notice there's some locating holes here that allows you to adjust your baskets
at whichever height you desire.
The locating pin goes right through and then the little sleeve drops down on top.
You will need to rotate that so that it locks in.
The basket then sits down on top of that, and your fixing clip goes in the top.
For the final basket, you can leave it where it is or you could move it up and have a higher
fixing.
But we'll just leave it at the bottom.
And that's how we install a corner rotating basket unit.