Thank you for purchasing your Kvant laser projector, In this video we will do our best
to get you up and running with Quickshow with your new projector as fast as possible.
First, open the case and pull the projector out.
Next remove all the cables and accessories.
You should have the projector, Trucon Power cable, Ethernet cable, 3 Pin XLR Cable, Estop
Button, Keys and the User interlock.
Start by using the 3 Pin XLR cable to connect into the Remote input on the laser projector,
then plug the other end into the Estop Button.
Grab the users interlock from the bag and plug that into the estop button as well.
From there grab the keys from the bag, putting one in the estop and one in the laser projector.
Next we will take the Trucon power cable and plug it into the projector, and plug the other
end into the mains.
Lastly we will pull up on the estop button to reveal the yellow stripe, and press the
start button until both LEDS turn on.
This will turn similar LEDs on, on the backside of the projector.
To be sure everything is set up correctly you should see the following LEDs, Power,
Start, and the FB4 controller should have the green LED static on.
Your projector is now powered and ready for control signal.
On all Kvant laser projectors you can daisy chain the Estop, and the ethernet cable, and
on lower power projectors you can also daisy chain the power,
To control your laser from a PC using Quickshow, also known as streaming mode, go to https://pangolin.com/pages/downloads
and download "QuickShow Full Version".
Once downloaded, run the installer and follow the install wizard to install.
While that is installing, grab the included Ethernet cable and plug it into your PC directly,
or through a switch into the back of the projector.
Also on the back of your laser is your FB4 control hardware, press down on the dial to
light up the display.
We will want to ensure the following: First under operational mode, make sure, BEYOND/QS
is checked.
Then under network setup, we will make sure "Auto Ip" is checked.
Lastly under scan guard, we will make sure scanguard is disabled.
Once Quickshow has finished installing go ahead and run the software.
Since hardware is connected to the PC, Quickshow will open.
QuickShow the first time you open it will go through a first time setup wizard.
Feel free to click whichever type of user you are, Beginner is a good place to start
if you are new, you can always change it later.
Next select high performance scanners, all kvant laser systems are high performance in
this case.
Then select, Three-Laser RGB projector.
And lastly, click "analogue color system".
Before you can have any laser output, click on "enable laser output" at the top right.
Then you can click any of the cues in the grid and they will output to predefined zones.
To change how your cues output from your projector, go to settings, projection zones.
Here you can change the geometric correction for each zone to position your content where
you would like.
Once that is all complete, you are free to use content from Quickshow on your new kvant
laser system!
If you still have questions about setup feel free to contact our support system by emailing
support@pangolin.com Thanks for watching!