Hey, everyone.
This is John, and today I'll be repairing a tab on this Toyota Camry headlight.
Fortunately, this is a clean break.
When we reposition it back on the headlight, everything aligns properly.
So, this should be a simple repair.
Use our Dent Driver to squeegee the tape onto the back side of the tab so that we can weld the front side.
So, what I've done here is I've v-grooved deep enough into the plastic so that when I start melting,
it's gonna melt down to the tape and essentially weld the front and back at the same time.
So that all I'll have to do on the back side is smooth with the airless welder.
I've got the air flow on my nitrogen welder turned down to about ten liters per minute,
so that I don't accidentally over-melt or burn something that I don't want to.
Alright, our tab is room temperature.
We'll snip these staples off and grind down the tips, cause we are leaving them in.
And that will do it for the back side.
You can spray a little primer on it and finish it out.
I'm gonna blow some hot nitrogen over it to just bring the color back into the plastic.
That's as far as I'm going with this tab.
So as before mentioned, if you wanna take this to the next step, you can prime this
and scuff it and prime it a few times.
But, that is as far as we are taking this repair.
That is a good, strong, quality tab repair.
We're finished!