1. Lift the car using a jack or place it over an inspection pit.
Required tools: Wire brush WD-40 spray Copper grease
HEX bit No.H10. Impact socket №12 Impact socket №21
Ratchet wrench Torque wrench Phillips screwdriver
Crow bar Hydraulic transmission jack
2. Undo the fasteners of the oil pan lower cover.
Use a drive socket #12. Use a Phillips screwdriver.
3. Remove the oil pan cover.
4. Clean the engine mount fasteners. Use a wire brush. Use WD-40 spray.
5. Support the engine in the oil pan area. Use a hydraulic transmission jack.
AUTODOC recommends: Make sure that the engine is supported.
6. Unscrew the fastener connecting the engine mount to the gearbox housing.
Use HEX No.H10. Use a ratchet wrench.
7. Unscrew the engine mount fastener that connects it to the subframe.
Use a drive socket #21. Use a ratchet wrench.
8. Remove the fastening bolts. Use a crowbar.
9. Remove the engine mount.
AUTODOC recommends: Carefully check the other engine mounts and replace them if necessary.
10. Clean the mounting seat of the engine mount. Use a wire brush. Use WD-40 spray.
11. Install the engine mount to its mounting seat. Use a crowbar.
12. Install the fastening bolts.
13. Screw in the engine mount fasteners. Use HEX No.H10.
Use a drive socket #21. Use a ratchet wrench.
14. Remove the support from under the engine.
AUTODOC recommends: Lower the hydraulic transmission jack smoothly, without jerks, to avoid damaging assemblies and mechanisms.
15. Tighten the fastening bolt connecting the engine mount to the gearbox housing. Use HEX No.H10.
Use a torque wrench. Tighten it to 57 Nm torque.
16. Tighten the fastening bolt connecting the engine mount to the subframe. Use a drive socket #21.
Use a torque wrench. Tighten it to 65 Nm torque.
17. Treat the engine mount fasteners. Use copper grease.
18. Reinstall the oil pan lower cover.
19. Tighten the fasteners of the oil pan lower cover.
Use a drive socket #12. Use a Phillips screwdriver.
20. Lower the car.