Hello everyone and Welcome to HowFixit.
In this video I gonna show you how to disassemble the Razer Blade 14 RZ09-01953 laptop, clean
it from dust and replace thermal paste.
To disassemble Razer Blade 14 you will need next tools:
Phillips 1 screwdriver Torx T5 screwdriver
Plastic tool Thermal grease
Antistatic brush Tweezers
In the description, I’ll leave links where to buy all the necessary tools.
Also I recommend using a magnetic mat in repair process and laying out each screw step-by-step
during disassembly, which is especially useful in the case of the Razer Blade 14.
This laptop has a lot of screws of different sizes and it is very important not to confuse
them during assembly.
Turn the laptop over and remove all the screws on the bottom cover.
Disconnect the battery cable from the motherboard.
To clean the motherboard from dust, use only an antistatic brush.
Now let's begin to the removal of the cooling system.
Now let's begin cleaning the cooling system from dust.
Remove all dust from the radiator and fan.
Remove all screws on the cooling system.
Now you can remove cooling system by lifting up from the motherboard.
Remove the old thermal paste from the surface of the CPU and GPU, as well as from the radiator.
If thermal grease is very dry and doesn't rub well, you can use isopropyl alcohol.
How to apply thermal grease.
Apply a small amount of thermal paste to the processor, then take a plastic tool and spread
it evenly over the entire surface of the chip.
If you still don’t know which thermal grease to choose, in the description, I left a link
to the video where I test different thermal greases and choose the best one for
the laptop.
Now you can install the cooling system and tighten
all
the screws.
If your laptop is still overheating after cleaning and replacing the thermal grease,
I recommend watching a video about the cooling pad for the laptop, or how to undervolting
CPU and GPU to reduce heat and increase laptop performance.
All links you can found in the description.
Well, that's all, you were on HowFixit and see you guys next time!