Welcome to the instructional video for the Burley 2-Wheel Stroller Kit
To install the wheels, open the towbar clamp by pressing the metals buttons and pulling
outwards.
Then slide in the wheel and lock into place.
To adjust the handlebar, unlock it by pulling the lever, adjust the bar to the desired position,
and lock it back in place.
Welcome to the instructional video for the Burley Stroller Kit
The stroller kit is attached to your existing tow bar.
Start by removing the safety strap from the tow bar using a 5mm hex key, and a 10 mm wrench.
Slide the stroller kit over the end of the towbar.
Align the holes on the stroller kit, tow bar and flex connector
Then place the bolt back through the strap, and through the aligned holes
Replace the nut and tighten the bolt
Use the remaining screws to tighten the outside of the stroll kit.
To switch from bike mode to stroll mode, loosen the knob, lower the wheel and lock it back
into place.
To adjust the handlebar, unlock it by pulling the lever, adjust the bar to the desired position,
and lock it back in place.
Welcome to the instructional video for the Burley Jogger Kit.
Start by inserting the quick release skewer into the jogging wheel.
Then disconnect the brake cable from its handle, by twisting the locking mechanism until the
cable can be released.
Slide the cable upwards between the frame and cover.
Then pull the cable through at the top.
Re-attach the brake cable to the handle, and then clamp the handle into place.
Next press the aluminum bars into the clamps, and lock them into place.
Be sure to align the holes in the back so the bars can be locked into place with the
safety pins, and the front wheel will roll straight.
Install the jogging wheel using the quick release, just like a bike tire.
Lastly, lock the brake mechanism into place using the provided quick release.
The wrist strap is installed by running itself through the end loop.