Hi everyone, welcome back to geardo. Today we will
show you how to replace the charging port on the iPhone XR mobile phone.
Before Starting, we need to have the right tools to proceed with the repair,
which You can find in the description.
First, Turn off the phone, then remove the sim tray,
and then undo two bottom screws by using a Pentalobe Screwdriver,
To remove the front screen, it needs to heat
gently around the screen edges until the pasted adhesive becomes soft.
For this, we are using a heating pad. Place the front screen side on the pad,
select the mobile phone HEATING option, and leave it till
it completes. Alternatively, you can use a heat gun or hairdryer.
Once the heating has completed, you need a
good suction cup or something similar to create an opening.
Here we are using a double-sided suction cup to lift the front assembly.
If not, you can use a regular suction cup to raise the screen and a plastic card pry tool
or triangle picker for separation and loosen up rubber gaskets on the frame.
Lift the screen, keep the direction like opening a book,
and remove the Shield by undoing three screws. And, Then Undo the battery plug.
Next, take out both screen & earpiece connector shields by undoing six screws.
Next, undo the screw, remove the bracket,
and disconnect the earpiece assembly plug and both lcd & touch connectors from the board.
Now the front screen unit can leave from the body.
Next, take out the sim tray.
Next, take out the sim connector slot by undoing three screws and the plug.
Next, take out the antenna bracket by undoing seven screws and the plug.
Next, take out the taptic engine by releasing the foam and three screws.
Next, take out the loudspeaker buzzer by undoing three screws.
Next, pull out the logic board by disconnecting eight connector plugs and five screws.
Be gentle and pull out the logic board.
Next, take out the bracket by undoing two screws.
Next, release two screws on the charging port connectors.
Next, apply some heat and pull out the not working charging port flex from the body.
Be gentle and pull out the microphone from the grills.
Next, place the new charging port connector in the body.
Ensure the placement and microphones in the grill.
Next, secure the charging port connector by adding two screws.
Next, secure the bracket by adding two screws.
Next, place the logic board in the body. And then secure nine connectors in the logic board.
Next, secure the board by adding five screws.
Next, secure the speaker by adding three screws.
Next, place the taptic engine by securing the plug and adding three screws with the bracket.
Next, secure the antenna bracket by adding seven screws and the plug.
Next, place the sim connector by securing the plug and three screws with the bracket.
Next, add the sim tray.
Next, add the pre-cut water seal adhesive into the frame. Please
note this tape will not completely protect the device against the liquid.
Next, connect the front screen to the body. Secure the LCD & Touch,
earpiece assembly and battery plugs into the board.
Ensure the connections are secured and then turn on the device for verification.
Next, place all three shields and the bracket by adding screws. Be gentle in this process.
Next, to clamp up the phone first, click in the top section first, then simultaneously
click sides and the bottom. Just make sure to put the pressure on the frame sides.
And finalize the installation by adding the sim tray and two screws in the bottom.
I
hope you have enjoyed the Repair guide.
Let us know if you have any queries; please like, share, and comment on our videos.