Push the end cap up fully and pull the brush bar out of the cleaner head.
Remove the end cap and set aside.
Hold your brush bar under tap water and gently rub to remove any lint or dirt.
Remove as much excess water as possible.
Stand the brush bar upright, and leave for at least 24 hours to dry.
Make sure the brush bar is completely dry before refitting it.
Reattach the end cap to the brush bar so that it's in the open position.
Take care to align the end cap correctly. Position at a 45 degree angle, otherwise it cannot be pushed down into place.
It is important to empty the bin when the dirt reaches the MAX mark.
Press the red wand release button and pull the bin away from the wand.
Hold your machine over a bin and push the red bin release button. Take care not to press the power button.
In order to clean the bin, you must remove it from the machine. Press the red release lever and slide the bin off the runner.
Hold a lint-free cloth under water to dampen.
Wring the cloth to remove excess water.
Wipe the bin clean with a damp cloth only.
Make sure the bin and seals are completely dry before refitting.
To refit the bin, insert the spine into the bin runner.
Then close the lid and make sure the bin and base click into place.
Wipe your Light pipe crevice tool with a damp cloth only, taking care to avoid the electrical connectors.
Make sure your Light pipe crevice tool is completely dry before using.
Wipe your non-powered tools with a damp cloth only.
Make sure your non-powered tools are completely dry before using.
Turn the filter anti-clockwise and remove it from the machine.
Before washing your filter, tap it gently to remove any dust or debris.
Wash the outside of the filter, rubbing with your fingers to remove the dirt.
Next, wash the inside of the filter; hold it upright under the water tap and agitate using a rotating motion.
Fill the filter with water, place your hand over the open end and shake firmly.
Repeat these steps until the water runs clear.
Empty the filter and tap firmly to remove excess water. Keep tapping until there's no water coming from the filter.
Leave for at least 24 hours to dry, in a warm place with plenty of airflow.
Check the filter is completely dry before refitting, or it could damage the motor.
To refit your filter, turn it clockwise until it clicks into place.