Having fun with your Traxxas vehicle sometimes means getting it dirty.
Cleaning it between runs will help keep your vehicle looking fresh and operating
at peak performance. Here at Traxxas we like to use an all-purpose cleaner and
air compressor or a can of compressed air, a variety of brushes and sponges, and
a few microfiber cloths. An old toothbrush is also helpful for getting
into those hard-to-reach areas and glass cleaner can be used to make the body
shine. If your vehicle is not very dirty, compressed air and a brush may be all
that you need. Always remove the battery when cleaning.
If water or liquid cleaner will be used, confirm that the electronic speed
control is labeled as a waterproof model. Nitro vehicles and some electric models
are not waterproof.
If the speed control is not waterproof or if you are unsure, check out our video
on how to remove the speed control and ensure a watertight seal on the receiver
box before using water or liquid cleaner. When doing a thorough cleaning it helps
to use a variety of brush types and sizes for the different areas of the
vehicle. Go over the vehicle with the cleaner and brushes as many times as
needed.
If needed you can remove the wheels or other components for easier access. When
cleaning, scrub the tires thoroughly, getting in between the treads and inside
the wheel. Experiment with different brushes to find one that is appropriate
for the size and tread pattern of your tires.
Now rinse off the truck with the low-pressure stream of water. Apply
another treatment of all-purpose cleaner and repeat the scrubbing and rinsing as
needed.
Towel-dry the chassis and components and then use the compressed air to remove
any moisture and debris.
WD-40 can be used on screw heads and bearings to lubricate and prevent rust.
Be careful not to over-do it, as too much WD-40 can attract dirt. A final wipe down
with a clean rag will help remove excess oil. Use the same process to clean the
body using a softer brush or microfiber cloth to prevent scratching.
Glass cleaner can add the finishing touch to make the body shine. Remember to
replace any components you removed during cleaning.
Now your vehicle is in top running condition and ready to get dirty all
over again.