In this video
I show you how to setup internet for your Cisco router
Connect your router to your computer using the console cable
If your computer doesn't have a serial port to connect to the console cable's serial end, use a DB9 USB to Serial converter
After to connect to serial end of the console cable to a USB port on the computer
Start the terminal emulator program on your computer
If you do not have a terminal emulator program installed download and install one such as putty
In this video Ge 0/0 is WAN port
and Ge 0/1 Port is LAN port
First configure pppoe using the following command line
Following command line
After entering the command line
Connect the network cable to the WAN port
Check the result
Next is to configure the DHCP server
Set the IP address for Port GE 0/1
DHCP
IP configuration
Plug the network cable into port GE 0/1
0 / 1
Plug the other end of the network cable into the computer
Finally configure NAT
Check the result
The computer is connected to the internet
and can access the internet
Hope this video will help you
Thanks for watching don't forget like and subscribe
You review the commands used