okay
so to reset your dstv recorder to factory defaults all you need to do
is to pick up your dstv remote and then you look for the blue logo
the dstv logo on your remote
you press on it then this menu open up you use the
left and right arrow keys over here arrow button
then you search for settings so you can use any
you come to settings use the arrow top and down
you move down to system settings the third one and then you tap ok
come down to the second one reset decoder settings
use the arrow down key and tap ok
so you come to this page you need to move down to
the last one reset to factory default
and then press ok
come down to reset the factory defaults you need to make sure that
you are resetting your decoder
okay so you press ok to proceed
booty
afterwards you move on to your installation wizard you proceed with the
installation wizard and then go ahead to scan the recorder
to get back all your channels
okay so
you choose your favorite language i will
proceed with english so you press ok to move ahead
so you come to this page
to be like this
if you are living in any listed countries
on the right side of the page botswana malawi mozambique
namibia south africa swaziland zambia and zimbabwe
you need to choose this satellite name and then you proceed with oki
you come down to manual setup press ok and then the lmb type
have to be universal most of the time it will be different
but it depends on the installation type in the decoder type
so most of the time you need to be universal and then you
move down to scan option because i'm not living
that listed countries i need to go back and change my
satellite name so if you are not living in these listed countries over here
if you are not living in this listed countries you need to change your
satellites name to e36b so it is for the rest of
africa so you choose this satellite and then
move ahead with the same steps come down to manual setup
you press ok the manual choose the lnb type to be universal most
of the time it will be different so you change it to universal
depending on the installation type in the decoder type
you come down to the scan option and your signal status
will be filling up
so you press ok to scan and after scanning you you're going to
get back all your channels
so
all right so thanks for watching bless up
you