Hey how is it going my name is Martin.
I work for SIRS-Electronics here in McAllen Texas.
And today I will be showing you how to connect LM3R Work Interface
With the Luminair Ipad App that uses our mix.
It's very simple to do as long as you follow this procedure
You will be able to connected successfully and it will be working really well for you
There's a couple of things you need to configure before anything else
The first thing you probably have to do; besides configuring the router,
You got to work on the interface itself.
In the back it has a series of dip switches.
The dip switch number 1 has to be in the on position.
This is the Art Net switch, once it has switch on the on position
It will tell the interface to go into Art Net mode
Which is what you want because that's what the Luminair App works off of.
Once you've done that you need connect you to your computer and
By following the instructions on the configuration utility
It will tell you that you got to change the IP address
And you got to set it to the same IP address as your router may be.
So, if the IP address on the Wi-Fi router, whatever may be you
Got to put it the same as the interface.
Once you have done that make sure you connect your power supply to it
And then you got a CAT5 cable and you connect on the port
Here on the front of the interface to port on the one on back of the router.
That's the only connection between the router and the interface.
Once you have done that you can go ahead and connect your DMX fixture.
In this case we are using the DMX driver and it's connected here on the front
To the DMX output of the Interface. Once that has been done
You will now get your iPad, make sure you go back to your settings.
You go to your Wi-Fi make sure its enable and then what you got
To do is to connect to the Wi-Fi signal from the router you just setup.
In this case I've named the router Luminair; just for the sake of making it easy,
But it can be whichever which ever named you can come up with.
So just go ahead and connect to that once you see that is connected
You can go back and open back the Luminair.
Once you've open up the Luminair you go to go to this top right hand corner.
There's a little dot there and make sure that Art Net is enabled
Make sure it is on Broadcast Node make sure the Subnet is 0
Input Universe is 1 Output Universe is 0 once you have that set
The rest of the settings are pretty much automatic and it's ready to go.
Make sure that your DMX fixture is set to the correct address
Because if you don't have it in the correct address it's not going to work.
In this case it's the only one we have connected so it's just on address 1.
Once you have done that you can configure your Luminair settings
On to whatever it is that you may need either 3 channel 4 channel 5 channel
Whatever it is that you need.
In this case we set it on RGB mode we are not using RGB lights
But it's the same concept and using this dimmer
You can actually turn on dim down these fixtures that I got going on here.
So, that's pretty much what you have to do.
Just remember when you edit the IP address on the interface make sure
Is the same IP address as your router itself.
And make sure the dip switch on the back number 1 is set to the Art Net position.
And after you've done that make sure that your settings on
The Luminair itself are set to the one I've mentioned.
Enabling the Art Net to broadcast Node, Subnet 0,
Input Universe is 1 Output Universe is 0.
That's pretty much all there is to it. It's not very complicated.
If you have any questions you can go ahead and contact us
At 956-522-2006 and I hope this video has help you out