Hey, it's Aaron.
And today we'll be going through the solution for CPU.
CPU. This guy also used to be called magic wands.
Anyway, this puzzle and many others are available at puzzlemaster.ca. Also,
this is a level eight. Okay.
So the whole goal of this is to disassemble - reassemble.
You take all these rods out; all eight of them and then put them back.
So you can see this one with the rubber grommets;
you're going to want to slip one of those rubber grommets off.
Cause this is your first pin to remove.
Then from here, more or less,
you can just kind of try pins and see what comes.
So that's your next one.
And they're going to have little grooves in it and they're going to vary.
So try that one.
And I'm just saving myself a little bit of time here and just organizing them
as I go. This puzzle's funner
if you just take them out and like shuffle them and then try to figure out how
they go back.
So we got our threes. So this one will have four grooves.
So that's it, disassembled.
So I'm going to now walk through these because these pieces are a
little bit different.
It's like you have two of these with the one groove and they're at different
positions. So the one closer to the edge,
will go over here. The one a little further away from the edge,
will go over here.
And we have similar circumstances with the other ones, as well.
So the one closer to the edge, will go here.
And this one that's more or less in the middle, almost, will go here.
And then the the third piece, or the three notch,
The one further to this edge, goes here. The one more or less in
the center... Actually, this one's almost to the other edge. Is this the..? Okay,
so I think they're in the same position. It's just,
you're closer to the edge going this way. This one,
you're closer to the edge going that way.
And then our four, we only have one, four, and we only have one zero unit,
no cutouts in it. And this is how I have my block.
So now we can just start assembling again. So we're going to take our four
and this is kind of like a countdown thing.
And you're going to have those grooves facing up,
cause that's where our notches are, is up.
Then, we'll put our 3 in, notches down
and the furthest side over here. This is or this is further,
this is closer to the edge
and those will just go in upside down.
Then we'll do our other three,
like so. Remember this is offset.
Put it face up.
And we're kind of going back and forth between the both axis.
So now we'll go with the two and we'll face those down.
We'll grab this two
and we'll face those up. Now we're onto the ones.
And our final one.
And then we can stick our solid rod through
and just put the donut on it.
Thank you for watching. If you enjoyed this video, we have plenty,
more like it on our YouTube channel.
Haven't had enough? Join the community on Facebook or Instagram.
Want more puzzles? We are a massive catalog of puzzles at puzzlemaster.ca.