Hey guys, my name is Jason with Mt. Baker Mining & Metals and today we are going to
do kind of a continuation sample video for you, this is that Iron or Steel Slag Pot skim
stuff that a customer sent us from the UK and we did a sample of this earlier when we
ran it through our Hammer Mill with a .8MM Screen and onto our Shaker Table and concentrated
the steel out wet.
And now the customer would like to see a separate sample done dry so, we are going to take this
stuff, run it through our 16" x 12" Hammer Mill here with a 1.2mm Screen, it's going
to discharge into this black tub and we are going to take it over onto our scrap line
and run it up the flat conveyor under the cross belt magnet which will pull out all
of the ferrous and magnetic material and then that's not magnetic will continue up through
and into a different bin, so we'll start this up, see how it goes and show you the results.
Ok, so this is the stuff that came off of the cross belt magnet, so this is the magnetic
fraction, we'll get this stuff weighed, looks like it's about 39lbs and I'm going to take
two off for the bucket so there's 37lbs of material that the cross belt magnet brought
off, into the magnetic fraction.
Ok and here is the nonmagnetic fraction, this is the stuff that went up under the cross
belt, I'm going to try and weigh both of these at the same time.
We will have to take off 4lbs for the buckets this time.
Looks like about 57.9lbs.
Ok so if I did my math right we figured it's about 40 percent magnetics to nonmagnetic,
what I'm going to now is take the stuff that ran under the cross belt the first time and
rerun it to see if we can scavage out of this stuff so we will fire it up again, we will
run it and see if we get any more magnetics off of the cross belt.
So this is the magnetic fraction from running the sample a second time, so we took all the
nonmagnetics, ran them through again and we only ended up with just a little tiny bit,
maybe a couple pounds.
So here, we will get the scale out.take off 2lbs for the bucket, so we ended up with about
another 2lbs, from rerunning it.
So we ended up 40 percent or so magnetics from our first run and then we added another
three by rerunning the tailings one more time.
So, be sure to watch our first video where we ran it wet on the shaker table and we are
going to pack these sample up, send them back to the customer, be sure to let us know if
you have any questions or if you would like any more information.
Thanks for watching and we will see you on the next one.