Hello everyone, today I show you how to disassemble iPhone XS Max and replace display module.
To disassemble the iPhone XS Max you need the following tools
Screwdriver set Tweezers
Opening plastic tool Plastic mediator
Suction cup for removing display In the description of this video, I left links
to the necessary tools and parts for replacement Before disassembling, turn off the iPhone
and remove the sim card tray.
Unscrew two screws near the lightning port.
Display glued around perimeter of iPhone XS Max and we need to heat the surface of iPhone for
open it.
Apply the suction cup to the bottom edge of the display and pull up on the ring.
Next, push the plastic mediator between the display and iPhone case.
From this position, evenly and slowly, open the display around the perimeter of iPhone.
The iPhone case opens like a book; the display opens to the right side.
Next, using a Tri-Wing screwdriver, unscrew the 4 screws and remove the metal panel.
Disconnect the battery cable from the mainboard.
Unscrew the 3 screws and remove the second metal panel.
Disconnect 2 cables of the display and the sensor panel cable from the mainboard.
Now you can remove the display.
To replace the display module on iPhone XS Max, you need to remove the panel with speaker
and sensors.
Unscrew 3 screws using a Tri-Wing screwdriver.
Using hair dryers, heat the front side of the display where located the sensor panel.
Carefully separate the sensors from the display housing.
If the light sensor cannot be remove with light movements to the sides, again heat the
front side of the display.
If this sensor is damage or replace, the Face ID will be lost, so special care is required
not to damage one of these components during removal and replacement of the display.
Before buying a new display module, pay attention to the presence of the holders for the camera
and sensors.
In the description of this video, I left links where you can buy new display.
Install the proximity sensor and light sensor.
Install the speaker and fasten the 3 screws.
The display module assembled, now we can install the display and test how everything works
before final assembly with gluing the iPhone case.
Connect 3 cables from the display module and only after that connect the battery cable
to the mainboard.
Turn on the iPhone and install the sim card.
Let’s test how everything works, and if it works well, let's go to the final assembly
with gluing the iPhone case.
Remove the old adhesive tape from the iPhone case.
After, using medicine alcohol wipe the surface of iPhone case and display module.
Now, take new adhesive tape and apply to the case.
With this tape, you save waterproof resistance of the iPhone.
I left link where you can buy this adhesive tape in description.
You can install the display without adhesive tape, but you will lose waterproof resistance.
Connect 3 cables from the display to mainboard.
Set metal panel and fasten 3 screws.
After, connect battery cable to the mainboard.
Set metal panel and fasten 4 screws.
Now, close the iPhone case ... and press down the display around the perimeter.
Fasten the two screws near the lightning port.
Now you can turn on the iPhone XS Max and use it.