We are going to run these down the jaw crushers get them about
3/4 inch minus than the hammer mill and than onto the shaker table and see what we get
okay we just finished running the
hard rock ore through the hammer mill
that's what making its way across the table now
what we see here is a awful lot of
quartz waster, light waste
very little black sand
we have been looking hard for gold
there might be some really fine gold here and there
nothing that's real obvious but we will brush down the table and see what we see
there is a nice line of gold there
get that down the table and watch that action
cleans down under the water bar
and when your running a couple hundred pounds of samples it really
it doesn't have enough time to make it all the way across
you brush it and look what you get
that's the way we like to see it, that's really very fine gold
the action of the table is pushing it up under the water bars
the water from the water bars is pushing away the black sand
and by the time it gets done were going to need to help it a little bit or it will take all day
but by the time it gets down into the trough
it will go into the high grade hole and be very clean
and there is the gold and its almost all clean now
most of the gold that came out of that rock came into the number 1 hole
This is what came through
a 325 mesh screen
actually a good percentage of what was on that table
was 325 minus
here is the materail that passed the 200 mesh
and was cought on a 325 mesh
it's still very fine to the eye
but
significantly larger than the 325 mesh
and here is the materail that
that did not pass a 200 mesh so all of this material is larger than 200 mesh
and probably ratio wise
it's 10 maybe 20 percent of the material
and I would say that the 200 to 325
would be 30 or 40 percent
and the minus 325 was another 30 or 40 percent
I didn't weigh it bus just visually
I'm saying 80 percent of the material passed a 200 mesh screen