StarMed CaStar R NEXT for NIV
This video shows the process of setting up, fitting and removing the CaStar R NEXT hood. Always refer to the Instructions for Use provided with each product. This video is not intended to replace the instructions for us
CaStar R NEXT For NIV Fitting and removing
Hood without underarm straps for non-invasive mechanical ventilation (NIV)
Available in six sizes to comprehensively cover the broadest range of adult patients
Size information is on the top and side of each box.
A tape measure is included on the outside so that the correct size can be selected without opening the box.
Inside the box you will find ...
Castar R Next hood
Rigid annular body
Inflation bulb
Instructions for use
Ear Plugs
Earplugs are included if you wish to use them.
Setting up the hood.
Open the bag using the perforated edge.
Reshape the hood.
Remove the patient access port cap.
Check the smooth operation of the anti-asphyxiation valve and place to one side.
Attach 22mm breathing system inspiratory and expiratory limbs
Start the ventilator.
Positioning and activating the hood
Two people firmly open the collar using their finger tips and thumbs along the rigid ring, so that the patient's head can pass through.
Position the inflatable cushion around the patient's neck and hook the fasteners onto the two front metal connectors.
Take the rigid annular body, open it and position it around the patient’s neck following the indications.
Close the rigid annular body behind the patient's neck.
Ensure that the 'FRONT' arrows are aligned.
Using the four fastening tabs hook the rigid annular body onto the metal connectors positioned on the ring.
Inflate the cushion with the inflation bulb. The cushion should be full, but not under pressure.
Then close the clamp.
Fit the patient access port cap. If required pull the anti-asphyxiation button until the hood inflates.
You may remove the pump if you feel no further adjustment is necessary.
Push the inflation tube into the slot under the rigid annular body
The hood is now set up correctly.
Using the patient access port
Twist the patient access port anticlockwise to access the patient’s face.
Lock the patient access port by twisting it clockwise.
If required pull the valve button using two fingers until the hood is pressurised.
Using sealed accesses for probes or catheters
Remove the access, position the probe/catheter or NG tube, then refit the access.
Removing the hood
Open the patient access port.
Probes or catheters that remain attached to the patient should be fed back into the hood.
Remove the rigid annular body.
Move the inflated cushion to the back of the patient's neck.
Two people firmly open out the collar and remove the hood.
Then turn off the ventilation flow.
CaStar R NEXT for NIV