Welcome to HowFixit and in this video, I will show you how to replace rear camera on the iPhone 11 Pro Max
What tools you needed to disassemble the iPhone 11 Pro Max:
Screwdriver set
Plastic mediator Suction cup for removing display
Tweezers Plastic opening tool
Adhesive tape for restore water protection In the description under the video, you will
find links where to buy all these tools and replacement parts for iPhone 11 Pro Max
Turn off your iPhone before starting disassembly.
Remove the 2 screws near the lightning port with a 0.8mm Pentalobe screwdriver.
Take a hair dryer and heat the display surface for 1-2 minutes at a temperature of 60-70
degrees Celsius.
Fix the suction cup on the bottom of the display and pull the ring up until there is a gap
between the display and the housing.
Insert mediator and disconnect the display from the iPhone case on all sides.
At the top of the iPhone, do not push the mediator much into the case, so as not to
damage the elements from the face id module.
The case opens like a book - the display to the
right.
Remove the 2 screws on the small panel and 6 screws on the large panel.
First, disconnect the battery cable and after 3 cables of the display.
Replacing the camera in the iPhone 11 Pro Max is an easy repair process and takes no
more than 5 minutes.
Remove the 4 screws and remove the metal panel.
Next, disconnect 3 cables of the camera from the mainboard and then you can remove the
rear camera.
In the description I left a link where to buy a new camera for the iPhone 11 Pro Max.
Before installing the new camera module, make sure there is no dust on the lenses.
The iPhone assembled and now you can check how the camera works before final assembly.
To check the iPhone, just connect 3 display cables and a battery cable, but only in that
order, first the display cables.
Check how each camera works.
If all the functions work fine, you can begin to the final assembly of the iPhone with the
restoration protect against water and dust.
Remove the silicone adhesive tape from the iPhone back housing.
Using isopropyl alcohol and a cotton swab, you can wipe the back housing, this is not
necessary, but it will not be superfluous.
Before attaching a new adhesive tape, make sure that you glue the right side on the back
housing.
This silicone tape restore resistance to water and dust.
This doesn't provide 100% waterproof for your iPhone but without this sticker, the display
will not hold well and dust will get inside the iPhone.
In the description you will find a link where to buy such a sticker.
Press the sticker on top, so it sticks better to the case.
Let's begin to connect the display.
First, connect 3 cables of the display, then the battery cable, and only in this order.
Install the panels and fasten
the screws.
Turn the display over and push it to the case.
Fasten the 2 screws near the lightning port and you can turn on iPhone 11 Pro Max.
That's all, I hope this video was useful for you and I helped restore your iPhone 11 Pro Max
See you soon on HowFixit.