repair clinic encourages you to perform this procedure safely
in this video
we will show one or more of these icons
to alert you went to use caution
as with any repair be sure you've unplugged the appliance before beginning
your first step is to remove the top panel screws
and set the panel aside
next depress the tabs on the control panel
and pull it off
disconnect the wire harness
remove the screws to release the circuit board bracket
remove the control bracket screws
and pull the bracket off
now removed the screws located at the base of the dryer
pull the lower panel out and then down to detach
reach into the lower cabinet to disconnect the door switch and moisture
sensor wire harnesses
remove the screws at the bottom
and at the top of the front panel
remove the mounting screws located inside the door
and pull the panel off
remove the lower bulkhead mounting screws
and loose in the upper screws
removed the mounting screws from the blower housing
lift the bulkhead off the upper mounting screws and set it aside
next remove the dryer belt by depressing the pulley to release the tension and
unthreading the belt from the pulley and motor shaft
now use the bell to lift up the drum
if still intact disconnect the wires from the old thermistor
and remove the mounting screws to release the thermistor assembly
install the new thermistor assembly
by aligning its position and securing it with the mounting screws
reconnect the wires
now replace the drum by aligning it's rim on the two rear rollers
and loop the belt around the tension pulley and motor shaft in a zig-zag
formation
rotate the drum to help align the belt
now reinstall the bulkhead by aligning it on the upper screws
tighten the screws
replace the lower screws
as well as the ones for the blower housing
reattach the front panel by lining it up on the cabinet
then secure it with the upper
and lower screws
as well as the screws inside the door
reconnect the door switch and moisture sensor wire harnesses
slide the lower panel up into position
and secure it with the screws
reinstall the control panel bracket
reattach the circuit board bracket
reconnect the control panels wire harness
and snap the panel back into place
replaced the top panel
secure it with the screws
and plug the appliance back in
to make sure it's functioning properly