Download the DJI Fly app on your mobile device
This video will help you get started quickly and safely.
watch this video to learn some basic flying skills
Before flying, remember to check the battery level
and micro SD card
Unfold the mobile
device clamps
remove the control sticks
from their storage slots
and screw them into place
then unfold the antennas
The cable on the left side of the remote controller
connects your mobile device to the remote controller
Unfold the aircraft arms
and remove the gimbal cover from the camera
To insert the Intelligent Flight Battery
Lightly press until the battery clicks into place
Press once
then again and hold to turn on the remote controller
and the aircraft
Place the aircraft on a flat surface
Be sure to aim the aircraft tail toward yourself
Open the DJI Fly app
Tap the Aircraft Status Bar in the app
increase the RTH Altitude until it is higher
than the highest buildings or structures in your vicinity
Tap the Auto Takeoff icon
on the left side of your screen for three seconds
to get airborne
Once the aircraft takes off
the Auto Landing icon will be shown
If you want to take off manually
push both sticks to the bottom inner (or outer) corners
to start the motors
Then push the left stick up to get in the air
In Mode 2 the left stick controls the aircrafts altitude and orientation
while the right stick controls
its forward, backward, left, and right movements
You can tap the top right corner
of your screen
to enter the remote controller menu
and change the stick mode
If the aircraft flies out of your line of sight
you can check the aircraft position and speed information
through the live map and flight parameters
The function buttons on the right side of the app
enable you to shoot photos, record videos
enter QuickShots
and enter Playback to
preview photos and videos
You can also tap Camera Settings
at the bottom right corner
to set or adjust camera parameters
By using the gimbal dial and the Shoot/Record button
You can adjust the gimbal's tilt
and control the camera during flight
tapping the Auto Landing icon
on the left side of your screen
and tapping the RTH icon in the prompt
for three seconds
or pressing and holding the RTH button
the aircraft will return
to home automatically
If the aircraft altitude is lower
than the RTH Altitude
the aircraft will ascend
to the pre-set RTH Altitude
and fly to the Home Point directly
If the aircraft altitude is higher
than the RTH Altitude
the aircraft will maintain
its altitude while flying back
to the Home Point
When the aircraft is over the Home Point
it will automatically land and the motors will stop
Use the auto landing slider
in the app to automatically land
the aircraft and stop the motors
You can also pull down the control sticks
to land the aircraft
After the aircraft lands
continue pulling down on
the control sticks until the motors stop
If you want to take out the battery
after the aircraft is powered off
open the battery compartment at the aircraft tail
then press the narrow battery-release button in
and slide the battery out to remove it
Ensure that the battery is sufficiently charged
before your next flight