We have advanced a little forward in our cafe racer project and decided to talk about work done
There is separate detailed video about spoked wheels installation at our channel
To install rear wheel we changed final drive cover, brake rotor and caliper
To install front wheel we made new axle and shortened forks
Gas tank was lengthened and cut to be on the same line with tail
Tail is mounted not rigidly through rubber gaskets to dampen vibration
Under load, it is a bit of flex
The tail is pressed down with the seat in two places
Four vertical pins with rubber bushings to limit movement of the tail in the horizontal plane
We used rubber bushing to prevent frame and stud contact
This mounting system securely and tightly fixes the tail with a seat
The battery is attached to the frame with rubber cushions also
In the future it will be fixed with rubber strip
We modified ABM Stremo number plate holder from kawasaki Z1000 -
it's compact and fits well
ABM Stremo allows to mount stop light with integrated license plate light and turn signals
We got all parts for clip-ons and controls
ABM adjustable clip-ons with ABM clutch assembly and ABM master cylinder look good
with push buttons controls switch
Biltwell one cable throttle and LSL grips fit well
Motogadget M-Unit we decided to mount under the gas tank
Also we mounted Motronic under gas tank
The front tank mount is moved relatively to the standard position
Gas tank backwards moving is limited with pins
Central mount with rubber bushing does not allow gas tank to lift
We decided to remove air box and install high flow air filter
To save AIS we will have to make oil catcher
We decided not to make custom exhaust and bought Remus full system
Left to do rearsets, wiring and fenders
Sponsor of the video is Suprotec
Suprotec makes automotive additives and lubricants aimed to protect engine
Subscribe and follow our instagram: stuntexclub