Hi. My name is Matt. I’m a support engineer at Agilent Technologies. Today we’re going
to show you how to install an N6781A module into a N6705B mainframe. So let’s get started.
So we’re going to take the top cover off here to access the place we are going to
install the module. So I just unscrew it and then kind of pull it back a bit, and then up.
Next we’re going to grab our module. There are holes on the bottom you want to line up
with these posts here. They kind of line the back up with that where a screw goes in.
So I just take it and line it up, put it down, and then press lightly so that goes
into the connection on the bottom there.
Next you’re just going to screw the module in. I usually start with the screw on the back.
Get these wires out of the way. You need a T10 screw that came with the unit
and a T10 tip on your screwdriver.
So just take that, hold the module’s rear and screw it in so it’s tight, but you don’t
want to over torque it, and now there’s another screw on the front.
So we’ll screw that in.
Again, so it’s tight, but don’t over torque it.
So our module is kind of screwed in. So the next thing we want to do is take the connector
that came with the unit and look at the legend on the back of the unit here on the label,
and match up the legend with the key here. So you want to take the black wire,
which is minus, and put it into pin two here.
Put it in pin two, tighten it up. Then you want to take the plus, which is the red wire
here, and put it into pin four.
The plus sense, which is orange, and put it into pin six.
Let’s make sure it’s open enough to get that in there.
Then the minus sense, which is this white one. This goes into pin eight.
And when those are all in just kind of do a little test, tug on it, and make sure they’re
pretty tight. You just plug it into the back here, into the connector like so. So now you
know your module is pretty much all set.
The last thing you want to do for the N6781A module is grab this connector off the back here
and slide it over and put it in this two-pin area here. This will connect the auxiliary
measurement port so that you can access it in the back, Now I just want to make sure
those channel two wires are out of the way, and then take your top cover, line it up,
put it down, push it over a little bit, and just gently screw it in with the thumb screws.
Now you’re ready to turn your mainframe on and use your unit.
So that’s how you install the module. It’s pretty simple. If you have any questions about
this process or any Agilent products, contact us at Agilent via the Agilent website at Agilent.com.
Thanks for watching. This has been Matt. Take care.