Intech is proud to introduce cold air intakes for your 2008-2013 C6 Corvette with a 6.2-liter
LS3 engine and today I'm going to show you how to install one on this Vette behind me.
The first thing we need to do is remove the factory air intake setup.
Do this by first removing the crankcase ventilation tube, this is done by simply sliding the tab
clock-wise and pulling up on the connector.
Then loosen the two hose clamps on the throttle body.
With both hose clamp assemblies loosened, you can pull and separate the bellow from
the factory air intake tube.
To remove it simply pull it upwards and remove it from the mounting grommets on the radiator
support.
We now have access to the mass airflow sensor connection.
Remove the connector by pulling the gray clip back and pressing on the black tab while pulling.
We can then completely remove the old air assembly.
With the factory air box removed, we can begin the installation and assembly of our Intech
cold air setup.
First, begin by removing the mass airflow sensor from the factory setup.
Use the torque's twenty bit to remove the two factory screws.
With the screws removed we can remove the mass air flow sensor and transfer it to our
Intech air intake tube.
Be sure and use the two supplied screws to retain it, you'll need a Phillips screwdriver
to do this.
Next, we need to install the nipple for the crankcase ventilation system, simply screw
it in hand tight and then tighten an additional quarter of a turn or 90 degrees.
Our next step is to install the two dry media filters to our Intech housing assembly.
Simply press it on until fully seated, position the clamps, then tighten with a nut driver.
Before we take our assembly back to the car, don't forget to install the vacuum formed
heat shield.
Simply line up the holes, and using the two screws provided, install and tighten.
Now we can take it to the car.
Now we can remove the old bellows assembly and toss it off to the side.
Using the new silicon bellow, install one of the included hose clamps and slip it on
to the throttle body.
Make sure that it is seated completely and then tighten.
Be sure and remove two of the grommets from the factory air box, you'll need to reinstall
them onto the studs that are attached to the radiator shroud before proceeding.
Now we can reconnect our mass airflow sensor, then install the cold air intake.
Use your finger and work the bellow around the lip of the cold air intake until it is
fully seated then press the housing down, this locks it onto the grommets that we installed
earlier.
I find it's easier if you undo the hose clamp completely and then work it around the throttle
body, then simply reconnect, position, and tighten the clamp with your nut driver.
And don't forget to reconnect the crankcase ventilation.
And that's all there is to our Intech cold air intake installation on our C6 Corvette.
We also have applications that include LS2, LS7, and LS9 Corvettes as well.
Thanks for watching, to find out more about Intech cold air intakes or to see if we have
your application available, visit our website at Holley.com