Print at least 18" of labels first.
Feed the Labels under the Dancer Arm!
Install a blank core the same width as your current label stock core. It must be a 3" inner diameter to fit on the rewinder.
Install the guide and turn the knob to lock it in place.
Install the support.
Make adjustments to the printer or the rewinder to ensure the rewind core is parallel to the label feed.
Also, make sure the rewinder is not skewed. It should be perpendicular so the rewinder base forms the top of a perfect "T" with the label feed output.
Feed the stock over the top of the core.
You may need to make additional adjustments to the guide to ensure the label stock is not pinched.
Tape the label stock to the core.
Turn on the Rewinder.
Start printing again.
Watch the rewinder to make sure the label stock is not rubbing on the right or left guides. Make adjustments while it is running to fix it.
Tip: If you start to see white space at the top of your labels or any vertical alignment issues, it could mean the rewinder is pulling too hard on your label stock and affecting the print position.
To fix this you can move the rewinder closer to the printer. The closer the better!
You can also lower the position of the rewinder (put it on the floor or low table) or raise the position of the printer. (Put it on a riser)
Adjust speed on the control panel.
When the job is finished, if you have your printer set to cut, the rewinder will produce a loud beep and stop running. (When the dancer arm contacts the base.)
Remove your finished roll.
Using your rewinder with the LX910 and LX3000.
Refer to the same subtitle instructions from the LX500 section at the beginning of this video.