Hi everyone, welcome back to geardo. Today we will
show you how to replace the Front camera on the google pixel 3a phone.
To start, we need to have the right tools to proceed with the repair,
which You can find in the description.
At first, turn off the phone,
take out the sim tray, and then remove the LCD screen removal from the front.
To remove the LCD, we are using a heating pad. Place the front screen side on the heating pad,
select the mobile phone HEATING option, and leave it till it completes. Alternatively, you can
use a heat gun or hairdryer around the screen edges until the pasted adhesive becomes soft.
Once you feel the Heating is enough, use a suction cup to lift the screen and then insert
a plastic card pry tool or something similar to cut the adhesive around the LCD screen.
Lift the screen gradually and disconnect the connector plug by undoing two screws and removing
the metal shield. There is an adhesive strip on top of the connector. It is missing from
this device. If you have the sticky, peel it off and place it while connecting the new lcd.
Next, take out the mid-frame plate by undoing fourteen screws. And then, by using a plastic
card pry tool or triangle picker, move around the phone to release the mid frame's clips.
Next, lift the mid-frame by the bottom, rise to 45% degrees, and release the proximity sensor.
And then take out the frame.
Next on the body, disconnect the battery connector and followed by
disconnecting five more connectors in the board.
Next, to take out the logic board, loosen the screw and gently lift by using a pry tool.
Next, gently turn over the logic board and take
out the broken front camera by disconnecting the plug.
Next, replaced the broken front camera with a unit and placed it on the board.
Next, place the logic board on the body and secure it by adding the screw.
Next, secure five plugs and the battery plug to the logic board.
Next, Connect the proximity sensor and place the midframe by adding fourteen screws.
Here, we take out the frame's proximity sensor and then connect it to the logic board.
When placing the mid-frame, gently pick the sensor through the opening and put it in the frame.
We are doing this to eliminate the difficulty of
clicking the sensor plug into the board while installing the frame.
Next, place the lcd screen on the body. And then, connect the lcd plug and add the
shield by inserting two screws. And also the Tape which we don't have but you may.
Before installing the LCD Screen, ensure it has enough glue on it;
if not, use B7000 glue or a new double-sided LCD adhesive.
Finally, we are adding bonding clips to tighten the LCD screen with the body. Leave it for some
time and remove it. On the other hand, you can use rubber bands and leave them for some time.
I hope you have enjoyed the replacement guide.
Let us know if you have any questions. Please, like, share, and comment on our videos.
DO not forget to hit the subscribe button.